1
EIRP-J1/EIRC-J2 Learn in Instructions
The GEN-TX-F1 transmitter is installed inside EIRP-J1 and EIRC-J2, allowing them to send
wireless RF signals to the Control Panel.
EIRP-J1 EIRC-J2
Identifying the Parts
1. Learn/Test
Button
2. Battery
(CR2)
3. Supervision Jumper Switch (JP2)
4. LED indicator (Red)
LED Indicator
In Normal operation mode, the LED Indicator remains off
except:
When the motion detector is in low battery condition, each
time it transmits a detected movement, the LED will flash for
6 times.
When the Tamper Switch is triggered, the LED will flash for 6
times to indicate it is transmitting “
Tamper
” signal.
When the Tamper condition persists, each time it transmits a detected movement, the
LED will flash for 6 times.
When the battery is exhausted, the LED will flash every 4 seconds.
Learning
For EIRP-J1, please first detach the back box and the mounting plate. For EIRC-J2,
please first detach the mounting base. (Please refer to VXI-R and FTN-R-PT
Installation Instructions for details.)
Pull out the battery insulator to activate battery.
Put the Control Panel into learning mode, refer to Control Panel manual for details.