1/3 HP - 1/2 HP AERATION SYSTEM
MAINTENANCE INSTRUCTIONS
WARNING/ATTENTION:
• Disconnect unit from electrical supply circuit at disconnect switch before opening.
Débranchez le cabinet du circuit
d'alimentation en utilisant l'interrupteur de déconnexion avant l'ouverture
• Always use parts that are supplied or approved by Vertex. Use of other parts may result in poor performance and could
create a hazardous situation and void the warranty.
Toujours utiliser des pièces qui sont fournis ou approuvés par Vertex.
Utilisez d'autres pièces peut entraîner de mauvaises performances et pourrait créer une situation dangereuse et annuler la
garantie.
• Do not use acid or corrosive cleaners. Follow instructions in manual for the appropriate cleaning methods.
N'utilisez pas de
nettoyants acides ou corrosifs. Suivez les instructions dans le manuel pour les méthodes de nettoyage approprié.
• Refer servicing to a qualified electrician under the following conditions.
Confiez l'entretien à un électricien qualifié dans les
conditions suivantes:
- When the power cord is damaged or frayed.
Lorsque le cordon d'alimentation est endommagé ou effiloché.
- When compressor fan, outlet or other electrical components need service.
Ventilateur du compresseur, de sortie ou
d'autres composants électriques besoin de service.
- If the cabinet is producing unusual noises or odors.
Si le coffret est produisant des bruits ou des odeurs inhabituels.
Vertex aeration systems are designed for low-maintenance and typically only require minimal scheduled maintenance. Periodic cleaning and/or
replacement of the compressor air filter, piston cup, and “Flexing” of the AirStation™ is required. Remember to keep cabinet air inlets and outlets
free of debris and weed growth to allow normal ventilation. If size and appearance of any surface boil has decreased from initial installation,
perform one or both of the following:
GENERAL CABINET CLEANING
1. Disconnect unit from electrical supply circuit at disconnect switch prior to opening
2. Using a portable vacuum or reg, remove debris, grass cippings and dirt from inside cabinet
3. Remove objects blocking the cabinet intake vents
4. Remove objects blocking the fan exhaust vent
5. Lubricate the locking machanism
6. Lubricate cabinet hinges
DOUBLE 5 MICRON AIR FILTER CLEANING/REPLACEMENT**
Air filter cleaning or replacement: Remove compressor air intake filter and wash with soap and water or replace. This should be done 2-4
times per year. Never re-install a wet or damp filter, allow sufficient time for it to air dry completely.
**On the inside of the cabinet lid or the outside back cover of this Owner’s Manual, you will find a Vertex parts list that provides you the necessary parts
information for ordering replacement parts. Call Vertex at 844-432-4303 with your 4 digit system warranty number or serial number off of the silver ETL sticker,
located inside the cabinet. Vertex can also supply you with the necessary replacement parts information.
No Filter
Twist to unlock
air filter
1
Remove old air filter
Insert new air filter
2
Line up the notches
Twist to lock
3
