T-Bolts
Flat
Washers
Mounting
Plate
Existing
Table
Fender
Washers
Hex Nuts
Flat
Washers
Existing
Table
Mounting
Plate
Hex Bolts
T-Nuts
Drill-Press Table
Caution:
To use this product safely,
always
follow the safety
instructions that came with your power tool. As with any power
tool accessory,
always
wear eye protection and hearing protection.
Attaching Mounting Plate to Drill Press
Mounting hardware is supplied for drill-press tables with through slots and those
with blind T-slots.
Through Slots
1. Align the
3
/
4
"
center hole in the
mounting plate with the center hole
of existing table.
2. Insert T-bolts with flat washers in the
recessed slots in the mounting plate
and through slots in the table.
3. Install fender washers and hex nuts,
and finger tighten.
4. Adjust mounting plate position on the
table as needed.
5. Tighten the four nuts.
Blind T-Slots
1. Place a T-nut in each T-slot in the drill
press-table such that they align with
the slots in the mounting plate. This
may involve some trial and error.
2. Align the
3
/
4
"
center hole in the
mounting plate with the center hole
of existing table.
3. Insert hex bolts with flat washers in
the recessed slots in the mounting
plate and into the T-nuts in the table.
4. Finger tighten the bolts.
5. Adjust mounting plate position on the
table as needed.
6. Tighten the four bolts.
