background image

 

AUTOMATIC & MANUAL

 

STORAGE HEATER RANGE

   

 

MODELS:   

SH6 - 6kWh   

 

SH12 & SH12A - 12kWh

   

 

 

 

 

SH18 & SH18A - 18kWh  SH24 & SH24A - 24kWh

INSTALLATION 

 

 

OPERATING

INSTRUCTIONS

IMPORTANT

PLEASE READ THIS LEAFLET CAREFULLY 

AND RETAIN FOR FURTHER USE
NOTE ALSO THE INFORMATION

GIVEN ON THE HEATER

 

The Installation must be carried out by trained 
personnel.

 

A means for disconnection must be 
incorporated in the 

fi

 xed wiring by a double pole 

switch with a contact separation of a minimum 
of 3mm and in accordance with the current IEE 
Wiring Regulations.

 

The heater must not be installed immediately 
below a 

fi

 xed socket outlet.

 

The heater is not suitable for connection to a 
30A ring circuit.

 

Do not position the heater under windows 
where curtains can contact the heater casing.

 

WARNING - THE SURFACES ON THIS HEATER CAN BE HOT.

 

This heater meets EN60335 safety requirements.  However, any heater type becomes hot in normal operation.  
Care must be taken to ensure that prolonged skin contact with the heater does not occur.

 

WHERE YOUNG CHILDREN, INFIRM PERSONS, OR THE AGED ARE PRESENT THIS APPLIANCE MUST 
BE ADEQUATELY GUARDED. Contact your installer or the manufacturer for further advice.

 

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental 
capabilities, or lack of experience and knowledge, unless they have been given supervision for instruction 
concerning use of the appliance by a person responsible for their safety.  Children should be supervised to ensure 
that they do not play with the appliance.

 

This appliance is very heavy and must be securely 

fi

 xed to a wall.  DO NOT UNDER ANY CIRCUMSTANCES 

ATTEMPT TO MOVE OR REPOSITION THIS HEATER WITHOUT SEEKING EXPERT ADVICE.

 

To maintain stability, it is essential that the heater is placed on a level surface.

 

This heater must be installed where it is impossible for switches and other controls to be touched by a person 
using a bath or shower.

 

IMPORTANT - Due to the newness of materials the heater will produce a slight smell for the 

fi

 rst few days of 

operation.  ROOMS MUST BE WELL VENTILATED AND YOUNG CHILDREN, CAGED BIRDS, OR PERSONS 
WITH RESPIRATORY COMPLAINTS MUST NOT REMAIN IN CLOSE PROXIMITY TO THE HEATER DURING 
THE FIRST 48 HOURS OF THE COMMISSIONING PERIOD.

 

IF, DURING ANY REASSEMBLY OF THE HEATER, A PART OF THE THERMAL INSULATION SHOWS 
DAMAGE OR DETERIORATION WHICH MAY IMPAIR SAFETY, IT SHOULD BE REPLACED BY AN IDENTICAL 
PART.

Summary of Contents for SH6

Page 1: ...nstaller or the manufacturer for further advice This appliance is not intended for use by persons including children with reduced physical sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision for instruction concerning use of the appliance by a person responsible for their safety Children should be supervised to ensure that they do not play wit...

Page 2: ...e at least 75mm from any end wall and at least 250mm below any shelf or similar projection Cut away any gripper rod or carpet which would prevent the heater sitting firmly on the floor 4 4 Mark the position of the two outside corners of the wall bracket with the heater pushed tight against the wall Remove the wall bracket from the heater by removing the screw at each end Place the heater to one si...

Page 3: ...ent up and out of the heater Carefully fit the bottom row of the back layer of bricks placing the two end bricks in position first with the re cess towards the element Fit the top row of bricks also with the recess towards the element 11 Refit the element which has been removed by feeding the tails down through the hole in the base insulation and into the connector block Ensure the element is full...

Page 4: ...nsate for weather variations CLEANING To maintain the appearance of the heater wipe occasionally with a dry cloth when the heater is cool Do not use abrasive powders of furniture polish RECYCLING 87658 1 08 2008 SETTING THE CONTROLS The controls are located on the top panel There are no user adjustable controls on the SH6 For models SH12 SH18 SH24 only Initially set the input to 4 If the heater do...

Reviews: