Mounting Brackets
(for Outside Mount)
19mm Round Head
Screw
Traditional Hold
Down Bracket
(for Inside Mount)
Required Tools
measuring
tape
drill with
2mm bit
phillips bit or
screwdriver
pencil
knife
How to install your
#65101-40160-D
Cordless
(Roller Blinds with Raceway)
Difficulty:
Included Hardware
The hardware can be found in
the small hardware box included
with your blind.
1
Blind Bracket Installation
Handle
Installation
continued…
How to install your
#65101-40160-D
Cordless
(Roller Blinds with Raceway)
Difficulty:
2
32mm
Hexagon Screw
(for Mounting Bracket)
①
②
③
Attach the blind brackets and extensions into the two ends of the raceway. Please decide
the tension dial is at the left or right side of the blind first, the side with the tension dial
should use the tension dial end bracket.
Make sure the extension bolt locks into the raceway’s dedicated hole.
First fit the blind bracket cover over the blind bracket. Install the raceway into the window
opening. We recommend securing the screws into the middle holes of the raceway first. This
would allow you to adjust the raceway left or right if required. Once the correct position has
been located, secure the screws for the holes.
Take care that the distance between the 1st screw and the window edge is at least 19mm.
1
2
Blind Installation and Removal
Installing outside the window frame
Installing inside the window frame
1
Blind Bracket Installation
①
②
Measure 75mm in from top left and top right of
where the blind will sit, and mark where the
screws will go.
When installing the mounting bracket, the
distance from the bracket’s mounting hole to the
edge of the window frame should be at least
19mm.
Make sure all brackets line up with each other
horizontally. Each bracket will require two 32mm
hexagon screws for the installation.
If more brackets are supplied, space them
evenly between the first two brackets.
3
4
19mm
Before installing the shade into the mounting brackets, please locate the lock pin in the
shade bracket on the end plug side. Slide the pin downward into the end plug to prevent
the shade from falling.
Insert the back edge of the raceway into the back plastic part of the bracket, and then
turn the raceway upwards so that the front rib of the raceway snaps into the bracket.
There are two ways to attach the shade to mount brackets....
A.
Front view…
Side view…
