![background image](http://html1.mh-extra.com/html/vectronics/vec-131kc/vec-131kc_assembly-manual_3768536001.webp)
LEC-131 KC Assembly Wanual
Aircraft Receiver
To install your receiver in the VEC-131KC matching enclosure follow these
i nstructions
(read all instructions before beginning ... take your time):
l. Find the front panel decal and rear panel decal; separate using scissors. Be sure
to leave excess decal material around the edges.
Put the rear panel decal on
first.
This is done by: a.) Remove all debris and oil from the chassis. This
should be done using a piece of cloth and alcohol.
b.) Remove the crack and
peel to expose the adhesive. c.) Place the decal on the rear panel without
securing it completely. d.) Gently rub the alignment circles with your finger--if
the circles are centered in the enclosure holes (also check the comer alignment
marks) secure the decal by rubbing and removing all air bubbles, e.) If the
alignment circles are not centered, adjust the decal accordingly then secure.
f.) Use a penknife, or small ExactoTM knife, to cut away the unused edges (cut
from the adhesive side) and cut out the component holes (cut from the
description side). g.) Repeat this procedure for the front panel.
2. Next, install the two L-brackets on the chassis using two of the 3/16" screws.
The longer side of the L-bracket must be connected to the chassis using the two
holes centered on each edge of the enclosure. Refer to the diagram on the next
page for location and orientation.
3. Install the two 1/2" mounting screws next. Insert the screws, from the bottom,
through the four holes relatively close to each comer of the chassis.
4. Place the two 3/16" round spacers on the mounting screws.
5. Now insert the PC board. This must be done by: a.) Remove the nut and
washer from R6 and R 18. b.) Insert the front of the PC board at an angle so the
controls enter their respective holes. e.) Push down on the rear of the board.
Make sure the mounting screws align with the mounting holes in the PC board
before pushing.
6.
`Jse the two hex nuts to secure the PC board.
Be certain all appropriate
omponents are centered with the enclosure holes before tightening.
Put the
washers and nuts--removed from R6 and R 18--back on and tighten.
10. Finally, place the four rubber feet on the bottom of the enclosure at the corners.
7. Find the knobs and switch cap. Align the switch cap with SWl and push it on.
If it is difficult to push on, then rotate it 90° and try again. Now put the knobs
on R6 and R18. You may need to loosen the set screw. Align appropriately
then tighten the set screws.
8. Locate the piece of double-sided tape. This is to be used for holding the 9-volt
battery clip in place. Locate a place on the underside of the top cover where the
battery will not interfere with any components. Peel off the backing of the tape
and stick it to the chosen location.
9. The top should be installed next.
Use the two remaining 3/16" screws for
securing the top to the L-brackets.
Make sure the L-brackets are aligned
properly.