![background image](http://html1.mh-extra.com/html/vector/opa2-2t-vc/opa2-2t-vc_technical-data-manual_3794064001.webp)
OPA2-2T(H)-VC Operation Terminal
Technical Data
Doc: 70-00-0379, V1.2, 20140213
© Vector Controls GmbH, Switzerland
Page 1
Subject to alteration
www.vectorcontrols.com
OPA2-2T(H)-VC
Operation terminal for TCX2
Features
Remote access to controller state, setpoints, inputs and outputs
Access to time schedule and clock settings
Access to configuration parameters
RS485 peer to peer communication according to proprietary
protocol of Vector Controls GmbH
The terminal adapts itself to the TCX2 controller used. One terminal
thus fits all the configuration variations of the TCX2 product range.
Internal temperature sensor
Internal humidity sensor (H version) or with AES-HT-A3 for
example
2 passive inputs: (only available with firmware version V1.1 and up)
Applications
Configuration and operation of TCX2 controllers
Remote supervision (RS485)
General Description
The OPA2-2T(H)-VC is a remote display and operation terminal for TCX2 series controllers.
Ordering
Item Name
Item Code
Description/Option
OPA2-2T-VC
40-50-0047
Operation terminal for TCX2-type controller with peer to peer RS485
communication and internal temperature sensor and 2 passive inputs
OPA2-2TH-VC
40-50-0023
As above with internal humidity sensor
Mounting location
Install the operation terminal on an easy accessible interior wall, approx. 1.5 m above the floor in an area
of average temperature.
Avoid direct sunlight or other heat sources, e.g. the area above radiators and heat emitting equipment.
Avoid locations behind doors, outside walls and below or above air discharge grills and diffusers.
Location of mounting is less critical if external temperature sensors are used.
Installation
1.
Connect the wires to be connected to the terminals of the power case according to wiring diagram
2.
Install the mounting plate to the flush mounting box. Make sure that the nipple with the front holding screw is
facing to the ground. Make sure the mounting screw heads do not stand out more than 5 mm (0.2”) off the
surface of the mounting plate.
3.
Ensure that the jumpers are set correctly.
4.
Slide the two latches located on the top of the front part into the hooks at the upper side of the mounting
plate.
5.
Carefully lower the front part until the interconnector reaches the mounting-plate. Continue pressing in a
gentle way until the front part is fully connected. While inserting the connectors, a slight resistance can be felt.
This is normal. Do not use excessive force!
6.
With a Philips-type screw driver of size #2, carefully tighten the front holding screw to secure the front part to
the mounting plate. This screw is located on the front lower side of the unit. There is no need to tighten the
screw too much.
Dimensions [mm] (in)
88 (3.5)
32 (1.2)
21
(0.8)
88 (3.5)
58 (2.3)