STONEVAC II PLUS
120V
25799 Jefferson Ave.
Murrieta, CA 92562
1-800-VANIMAN (826-4626)
www.vaniman.com
STONEVAC II PLUS - 08/21 Page 1
PACKING LIST
1 - StoneVac II Plus
1 - 2½” x 6’ Hose
1 - Dust Bin Bag
1 - Elastic Retaining Band
1 - Power Cord
INSTRUCTIONS
1. Remove the unit and other parts from the box; check against the packing list. Remove the hose from
inside the dust bin as well as any protective paper packing material.
2. Plug the removable power cord into the back of the unit. Try the unit by pushing the switch to the
ON
position making sure the AutoPilot
AUTO/MANUAL
switch is in the
MANUAL
position.
3. The vacuum hose supplied slips onto the vacuum connection near the front panel of the unit and the
other end connects to the collection device desired. The ideal location for the StoneVac II is under the
bench where the user works. The single station hose supplied is 2½” x 6 feet long and accordions to
the desired length. Hose extensions and adaptors are available from your dealer. We recommend,
however, that you try to keep the total length of hose less than 6 feet between the StoneVac II and the
dust collection point. Longer hose will reduce suction. See the enclosed accessories guide for collection
device details or call your Vaniman dealer.
CONNECTING THE AUTOPILOT
Introduction:
The
AutoPilot
allows you to control your dust collector from a micromotor or lathe. When
you start your micromotor, the dust collector will start automatically. When you stop your
micromotor, the dust collector will continue for a short period of time to allow for the residual
dust to be cleared.
1. Turn the unit on at the main power switch. Move the other switch to
AUTOMATIC
, the dust collector
should turn off.
IMPORTANT SERVICE INFORMATION:
SAVE SHIPPING BOX AND FOAM FOR FUTURE
SERVICE. SHIPPING WITHOUT PROPER FOAM
MAY CAUSE DAMAGE TO UNIT
WARNING:
The Autopilot will accommodate a micromotor,
electric handpiece, or lathe that does not exceed
5 amps, 115VAC, total
