STONEVAC AM
120V
25799 Jefferson Ave.
Murrieta, CA 92562
1-800-VANIMAN (826-4626)
www.vaniman.com
SV-AM-07/23 Page 1
PACKING LIST
1 - StoneVac for Additive Manufacturing
1 - Plastic Disposal Bag
1 - Power Cord
1 - Interface Cable
1 - Large Accumulator
1 - 2.5" x 6’ Hose
INSTRUCTIONS
1. Remove the unit and other parts from the box and check against the packing list. Remove the hose
and power cord from inside the dust bin as well as any protective paper packing material.
2. Plug one end of the power cord into the back of the StoneVac and the other end into a designated
15 AMP circuit. Turn on the StoneVac by flipping the main power switch on the back of the Unit into
the
ON
position. Once the switch is in the
ON
position, the red LED indicator on the front of the unit
will illuminate.
3. The 2.5" vacuum hose supplied slips onto the vacuum connection in the back of the unit and the
other end connects to the top of the Large Accumulator. The 1.5" vacuum hose connects from the
Large Accumulator's inlet arm to the collection point in your post-processing area. The ideal location
for the StoneVac is near the post-processing area. Hose extensions and adaptors are available from
your dealer. We recommend, however, that you try to keep the total length of hose less than 6 feet
between the StoneVac and the dust collection point; longer hose will reduce suction.
IMPORTANT SERVICE INFORMATION:
SAVE SHIPPING BOX AND FOAM FOR FUTURE
SERVICE. SHIPPING WITHOUT PROPER FOAM
MAY CAUSE DAMAGE TO UNIT
Fig. 1
