![background image](http://html1.mh-extra.com/html/van-guard/vg162s/vg162s_fitting-instructions_3341276001.webp)
Fitting Instructions - Read instructions carefully before fitting and follow them for correct use
IN8160
Bulkhead - VG162S / VG162P
This FITTING INSTRUCTION is the property of VAN GUARD ACCESSORIES LTD. and must not be used for
manufacturing purposes, copied nor communicated in any way to third parties without written
permission from VAN GUARD ACCESSORIES LTD.
IN8160_B
Van Guard Accessories Ltd
Fair Oak Close, Exeter Airport Business Park,
Exeter, Devon, EX5 2UL
www.van-guard.co.uk
IN8160 - PAGE 1 OF 3
MA6030
X1
(RUBBER EGDING 950MM)
FX4012
X5
(M6X16)
FX4016
X5
(M6)
FX4017
X10
(M6)
ME0361
X1
(BOTTOM)
VG162S =
ME0336
X1
VG162P =
ME0337
X1
(TOP)
FX4087
X21
(No14 x 1/2”)
!
DRILL (Ø4.5MM) X1
SPANNER (10MM) X1
PH SCREW DRIVER X1
TOOLS REQUIRED
??
1. You should note that it is the responsibility of the installer/s to ensure that when drilling holes in to your
vehicle to take fixings, care must be taken to ensure that the fuel line, tyres, fuel tank, wiring loom, exhaust,
bodywork and brake lines etc. are not damaged. Whilst every effort has been made to ensure our products can
be safely fitted, changes to vehicles sometimes occur so it’s always necessary to check before drilling.
If in doubt refer to the vehicle manufacturer’s dealership.
2. When drilling, use as short a drill bit as possible to prevent damage to the vehicle. Use corrosion protection
when drilling the vehicle.
3. Wear the appropriate protective equipment (safety glasses & gloves) while fitting this product.
4. Regularly inspect all fixings and parts. Any damaged or worn parts should be immediately removed the
vehicle and replaced.
5. Retain instructions for future use. It is important that the end user receives this document.
CAUTION - IMPORTANT NOTES