1
September 2018
OPERATION MANUAL
GV34
GV34 Remote Control
used on Valor heaters 738, 739-72 and RF24B
Push-on
Connector
Connect Remote Control Receiver
1. Connect the wiring harness to the receiver box,
by pushing the wire connector on to the receiver
circuit board. The plug will only go on one way so
please ensure that the wires are pointing up and
the slot in the board is in line with the tab on the
wiring harness plug.
2. Connect the wires as shown. Please note that the
“L” connectors are diff erent sizes; the smaller one
fi ts to the lower connection and the larger one the
top connection on the top left hand side of the
valve. The other two wire connectors can be fi tted
to either terminal located to the left of the fl ame
control button.
3. Remove the remote control receiver lid.
4. Fit four AA 1.5 V
alkaline
batteries. Refi t the lid.
5. Place the remote control receiver on the base of
the fi replace beside the valve.
6. Fit the 9 V
alkaline
battery to the handset
transmitter.
Remote control operating instructions are on
following pages of this manual and are supplied
with the remote control kit.
GV34 Valve
Receiver
Push-on Connector
CAUTION
DO NOT USE
a screwdriver or other metallic object to
remove the batteries from the receiver or the handset!
This could cause a short circuit to the receiver.
CAUTION
DO NOT PUT BATTERIES IN THE REMOTE
CONTROL RECEIVER until the wires
are connected to the burner control
unit as short-circuit could result in the
destruction of the electrical components.
