Issue 4
1 947654
VE8011, VE8011R
NETWORKED STATION PORT
INTRODUCTION
The VE8011/VE8011R Networked Station Port
allows most loop start terminal devices to be
connected to a managed IP-based LAN/WAN.
The VE8011 is designed for wall or table placement.
The VE8011R is des
igned for 19” rack mounting (1U).
SPECIFICATIONS
Access Methods
PBX, FXO Port
POTS telephone set
Features
RJ-45 for network connection
1 RJ-11 telephone connections
2 Relays with Form C contacts
Front panel activity LED
Network activity LEDs
2 REN
2.5mm jack for DC
Power over Ethernet 802.3af compatible
Dimensions/Weight (VE8011)
1.38 H x 6.13" W x 5.25" D
(3.50cm H x 15.6cm W x 13.33cm D)
Weight: 1.25 lbs. (0.57 kg)
Dimensions/Weight (VE8011R)
1 Standard 19” Rack Unit
1.75 H x 16.50" W x 5.25" D
(4.45cm H x 41.91cm W x 13.33cm D)
Weight: 5.10 lbs. (2.32 kg)
Nominal Specifications
Input Impedance:
600 Ohms
Input Level:
-10dBm
Output Impedance:
600 Ohms
Output Level:
- 10dBm nominal
Relay Current:
1 AMP @ 24VDC
Nominal Power Requirements
Via rear panel barrel connector:
Voltage:
24VDC
Current:
325mA
Via 802.3af PoE Ethernet Switch:
802.3af:
Class 3
VE8011
VE8011R
Environment
Temperature:
0 to +40° C
Humidity:
0 to 85% non-precipitating
INSTALLATION
NOTE: The telephone system referred to in
this manual is the customer premise
equipment such as an electronic key system,
a PBX or a dedicated single line telephone
sets. The VE8011/VE8011R is not intended for
direct or indirect connection to the public
telephone network. When used with a
customer premise telephone system such as
a key system or PBX system, these units are
interfaced to the system via a fully protected
trunk port or system central office port, which
is a fully protected interface device. Also, the
host system must be configured to disallow
central office trunk conferencing in order to
prevent indirect connection to the public
network.
