![background image](http://html2.mh-extra.com/html/vac/v200-positioner/v200-positioner_fine-tuning_3108532001.webp)
If the
positioner and the feedback
have been
accurately calibrated
but
the feedback is not
linear the
steps below
will help improve feedback linearity.
Important Note:
A full gauge set
is very helpful when trying to fine tune a positioner and feedback. Being able to see the
pressure movement, and their reaction to signal changes helps you know the positioner is
responding.
Check list.
• Make sure air is turned on.
• Will need to make sure you have 2 good loop calibrators.
• One for generating a 4 to 20mA signal
• One for reading a 4 to 20mA signal (BOTH UNITS MUST BE SET TO
HAVE A 24V LOOP
SOURCE) IF YOU DO NOT SET THE CALIBRATOR
IN THE 24V source SETTING, YOU
WILL NOT READ ANYTHING ON THE
FEEDBACK.
• Normal flat head screwdriver
• Tweeker (small screwdriver) for adjusting span and zero trim pots settings
on the feedback.
• Check 4mA and 20m
A. O
n the feedback
,
this will be done
b
y
mechanically
moving the valve/actuator as stated below:
• At 4mA make sure that the valve is not open/closed by manually pushing up
on the balance
arm that is connected to the spool valve. There should
be no
movement; this can be seen/read
in the feedback. If you see
movement in
the feedback, make adjustments to the zero on the
positioner. NOT THE
ZERO ON FEEDBACK.
• At 20mA feedback make sure the valve is open/closed by manually pushing
down on the
balance arm that is connected to the spool valve. There
should
be no movement; this can be
seen in the feedback. If you see
movement in
the feedback, make adjustments to the span on
the positioner,
outer silver
wheel. NOT THE SPAN ON FEEDBACK.
• Once these adjustments have been made
:
• Give positioner a 4mA control signal. Make adjustments to the
z
ero
on
FEEDBACK as necessary to get the output close to the 4mA input.
• Give positioner a 20mA control signal. Make adjustments to the
s
pan on
FEEDBACK as
necessary, to get the positioner input close to the 20mA
output.
V200 Fine Tuning
Positioner Feedback