background image

Install

NT-X5

The USFT NT-X5 Install Guide

USFleetTracking

Please verify that your device is activated prior to installation.

When activating a unit, refer to the device MID# on the top of the 
tracking device. (Reference Image A.)

The NT-X5 requires a standard 3-wire installation to operate effectively. 
Please familiarize yourself with the following wire colors and functions.
 

 

 The 

red

 wire (power) should be directly wired to a constant 8V - 16V power source found at the 

 

key source or fuse panel.

 
 The 

black

 wire (ground) should be securely fastened to a grounded screw or to chasis ground.

 
 The 

white

 wire (ignition) is the ignition event wire that is best installed directly to the ignition wire. 

 

Ensure that power to the ignition wire is available ONLY when the vehicle ignition is turned on. All 

 

makes and models of vehicles are different - we recommend you make sure that you know your 

 

particular vehicle’s Constant and Ignition wires and their specific color(s) prior to installation.

 The 

green

,

 

brown

 and 

yellow

 wires (outputs) can be used to honk the vehicle’s horn, unlock its doors 

 

remote start the engine, and disable/enable the starter.

 The 

blue

orange

,

 

purple

, and 

grey

 

wires (input) can be used to monitor many functions such as PTO 

 

activity (Power Take Off), emergency lights, panic switch, etc or a specified input for the customer.

Step 1 > Wiring and Installation

405.726.9900  |  2912 NW 156th Street  |  Edmond, Oklahoma  73013  |  usft.com

Thank you for purchasing your new GPS vehicle tracking system!

Installation of your new GPS tracking device couldn’t be easier. 

Just follow these simple steps.

Step 2 > Status LED Lights

After installing the unit, and prior to securing under the dash area, make 
sure the unit has a solid 

green

 light and a blinking 

orange

 light that goes 

solid for 1 second, then repeats the pattern. See table on page 2 of this 
Installation Guide for troubleshooting when one or both does not occur.
(Reference Image B and Table on Page 2.)

Image A

Image B

Red

 

wire

Black

 

wire

White

 

wire

Green

 

wire

Brown

 

wire

Power

Ground

Ignition input

Starter kill

Honk Horn

12 VDC constant

Ground

Key (on)

Output (150 mA)

Output (150mA)

* Must be connected for device to work properly.

*

*

*

Unlock Door

PTO 2 (panic)

PTO 3

PTO 4

PTO 5

Yellow

 

wire

Blue

 

wire

Orange

 

wire

Purple

 

wire

Grey

 

wire

Output (150 mA)

Input - Bias low

Input - Bias high

Input - Bias high

Input - Bias high

Reviews: