ES02 Diagram
Set Up Guide
Mode Select Guide
Manual Tilt Setting
Changing Mode Using Function Button
Pan (horizontal) control motor
Notification LED /
Function button
Power button
P１
Tilt (vertical) control motor
Roll (spin) control motor
mini USB port
Battery indicator
Do not drop, hit or apply excess pressure to the product.
Please attach a smartphone or a camera before turning on the power. If you turn on without a
smartphone or a camera attached it may move unstably and cause of damage to the product.
Assemble the product and attach a smartphone or a camera using the method listed in the
instruction manual.
Please
do not
attempt to personally repair, modify or dismantle the product.
Please
do not
connect the mini USB port of this product directly to a smartphone or a camera.
Please
do not
use any batteries other than the official rechargeable batteries. Unofficial batteries can
cause damage to the product.
Please
do not
use any chargers other than the official charger. Unofficial chargers can cause damage
to the product.
If there is something wrong with this product please discontinue use and contact our support center
([email protected]).
・
・
・
・
・
・
・
・
Safety Guidelines
Thank you for purchasing our product. Please read this manual carefully before using the product
and follow the safety guidelines.
1st Revision 2015/9/1
UPQ Inc. All rights reserved.
Battery Indicator Guide
Flash 3 times (Blue)
Flash 2 times (Blue)
Flash 1 time (Blue)
Flash repeatedly (Blue)
Fully Charged
Medium
Low
Charging Required
*If the indicator light is red the device requires resetting.
Please refer to “Changing Modes Using The Function Button”
for how to reset.
Battery Indicator
Battery Charge Remaining
The ES02 has 5 different modes available.
・Horizontal tracking mode
Lock the tilt control motor and roll control motor for smooth horizontal tracking.
・Horizontal and tilt tracking mode
Lock the roll control motor for smooth tilt and horizontal tracking.
・Immobilize mode
Lock all the motors.
・Horizontal tracking mode (upside down)
Use this mode when you want to use a camera in a position at the bottom of the handle rather
than at the top. Lock the tilt control motor and roll control motor for smooth horizontal tracking.
・Sleep mode
Stop all motors temporarily without turning off via the power button.
To manually adjust the tilt angle, alter the tilt angle within 10 seconds of powering on the ES02
and hold in that position for 0.5 seconds to save and lock the tilt angle position.
*Not available when “horizontal and tilt tracking mode” is selected.
Holding clip
Press 1 time
Press 2 times
2 Second long press
Press 3 times
4 Second long press
Press 4 times
Notification LED
Mode
Single flash
Double flash
Always on
Single flash
Always on
Single flash
Horizontal tracking mode
Horizontal and tilt tracking mode
Immobilize mode
Horizontal tracking mode (upside down)
Sleep mode
Reset
Function button
User Manual
1.Insert official batteries
Remove the cap where the power button is located, insert the 2 official batteries
then reattach the power button cap.
2.Attach a smartphone or a camera
Using the holding clip, attach a smartphone or a camera. Ensure the smartphone
or a camera is securely attached before continuing.
3.Power on
Turn on by pressing the power button.
4.Select mode
By pressing the function button you can switch between the ES02ʼs different modes.
(Please refer to “Mode Select Guide” for more information)
