© UPLIFT Desk
• 1-800-349-3839 • [email protected] • www.upliftdesk.com
®
UPLIFT Adapt Clamp
™
Instructions
UDA100~clamp
Step 1
(Optional - for desks thicker than 1.5 inches)
Measure your desktop thickness. If it is 1.5’’ or thinner, proceed
to Step 2.
Remove the rear bolts that connect the top and bottom parts of the
clamp with the small Allen wrench (Part H). Unscrew the long bolts
from the bottom clamp.
Flip the bottom clamp upside down, and reattach to the top clamp.
Reinsert the long bolts. This will allow the clamp to fit desks thicker
than 1.5’’
Step 2
Loosen the long bolts under the clamp assembly enough to allow you
to slide the entire assembly onto the back edge of your desktop. Hold
the clamping plate between the desk and the long bolts, aligning the
holes in the plate with the ends of the bolts. Tighten the long bolts with
the larger Allen wrench (Part G) to secure the clamp onto the desk.
Part C
front panel assembly
Parts D
short vertical connector
(optional)
Part B
keyboard tray
Part G
Allen wrench
(large)
Part F
bolt covers Qty. 6
Part H
Allen wrench
(small)
Part I
M6*8 bolts Qty. 8
Desk not included. Use your own desk surface.
Part J
M6*12 bolts Qty. 4
Part E
clamp assembly
top clamp
bottom clamp
clamping plate
long bolts
Part A
Adapt Clamp™ main assembly
