![background image](http://html.mh-extra.com/html/universal-tool/ut8612-b/ut8612-b_operator-instructions_1059320001.webp)
Manufacturer/Supplier
Product Type
RPM
Cycles Per Min
Tel No
Fax No
(01494) 883300
(01494) 883237
Model No/Nos
Serial No
Product Nett Weight
lbs
Kg
Recommended Use Of
Balancer Or Support
Recommended Hose Bore
Size - Minimum
Recommended Max.
Hose Length
Ins
M/M
Ft
M
Foreseen Use of the Tool
The tool is designed for the purpose of chipping, riveting and
scaling of metals and stone. In general terms a reciprocating free
piston in the cylinder of the tool imparts a blow to the chisel or
working attachment. A list of suitable equipment to use with this
tool can be provided by the manufacturer. Do not use the tool for
any other purpose than that for which it was designed without
consulting the manufacturer or the manufacturer’s authorised
representative.
Do not modify the tool for it’s use as a chipper etc. or for any
other purpose without first agreeing any such modification with
the manufacturer or the manufacturer’s authorised representative.
Putting Into Service
Air Supply
Use a clean lubricated air supply that will give a measured air
pressure at the tool of 90 p.s.i./6.3 bar when the tool is running
with the trigger fully depressed. Use recommended hose size
and length. It is recommended that the tool is connected to the
air supply as shown in figure 1. Do not connect the tool to the air
line system without incorporating an easy to reach and operate
air shut off valve. The air supply should be lubricated. It is strongly
recommended that an air filter, regulator, lubricator (FRL) is used
as shown in Figure 1 as this will supply clean, lubricated air at the
correct pressure to the tool. Details of such equipment can be
obtained from your supplier. If such equipment is not used then
the tool should be lubricated by shutting off the air supply to the
tool, depressurising the line by pressing the trigger on the tool.
Disconnect the air line and pour into the intake bushing a
Work Stations
The tool should only be used as a handheld, hand operated tool.
It is always recommended that the tool is used when standing on
a solid floor. It can
be used in other
positions but
before any such
use, the operator
must be in a
secure position
having a firm grip
and footing and be
aware of a
reaction force on
the hand as result
of the tool doing
work.
No
Air Pressure
Recommended Working
6.3
bar
90
PSI
Recommended Minimum
n/a
bar
n/a
PSI
Maximum
7.0
bar
100
PSI
Personal Safety Equipment
Use - Safety Glasses
Yes
Use - Safety Gloves
Yes
Use - Safety Boots
Use - Breathing Masks
Use - Ear Protectors
Yes
Page No 1
0.401 Shank Air Hammer
UT8612-B Round Shank
UT8613-B Hex Shank
3.52
1.6
3/8
10
30
10
3,500
Includes - Foreseen Use, Work Stations, Putting Into Service,
Operating, Dismantling, Assembly and Safety Rules
Operator Instructions
Important
Read these instructions carefully before installing, operating,
servicing or repairing this tool. Keep these instructions in a safe
accessible place.
Universal Air Tool Company Limited
Unit 8
Lane End Industrial Park
High Wycombe
Bucks
HP14 3BY
Vibration Level
Test Method
Tested in accordance with ISO
standards 8662 Parts 1 & 2
13.0
Noise Level
Sound Pressure Level 102.7 dB(A)
Test Method
Tested in accordance with Pneurop
test code PN8NTC1 and ISO Standard 3744
Sound Power Level 115.0 dB(A)
Metres / Sec²