Installation of the TCP1
Step 1:
Remove face cover # 80887A (#10 below)
Step 2:
Attached TCP1 with same screws from face cover (#below). Tighten securely
into place.
Note: position the TCP1 so that the air cylinder is on the left hand side of the sewing
head.
Step 3:
Attach air filter/regulator where best suited for operation. Make sure that the
tubing is NOT pinched and clear of moving parts.
Step 4:
You will need to supply air and fittings for filter/regulator with ¼” port size NPT
with following specs: Max air pressure: 150 psi, 125 deg F, 18 cfm air supply
Step 5:
Once system is installed, adjust pressure on regulator by turning the dial.
Counter clockwise rotation to decrease pressure, clockwise to increase.
Set at 40-60 psi
