Pull out screen and
clip down
www.unilite.co.uk
FEATURES
• Super bright 1100 Lumen white 6500k Cree LED
• Easy twist smooth dimming switch
• Retractable light shield to provide spot & flood beam options
• Wider angle light spread
• 45° rotational head
• IPX6 water resistant
• Fully adjustable non-slip silicone headbands
• Hard-shell protective zipped storage case included
• 2 x High power 2600mAh Li-ion 18650 batteries included
• Parallel circuitry (works with 1 or 2 batteries)
• Useful battery level and charging indicator LEDs
• Faster USB Type-C charging - 4 ½ hours
BATTERY - 2 x 3.7v 2600 mAh li-ion rechargeable batteries (inc)
DIMENSIONS - Headtorch: 38 x 60 x 45 mm
Battery Pack: 53 x 90 x 45 mm
WEIGHT - 275g (with 2 batteries)
ADVICE & IMPORTANT INFORMATION!
Do not look directly at the LED. Do not operate in direct sunlight or extreme temperature
conditions (below -30°C or above 60°C).
The LED will become hot when switched on; do not touch and do not place face down on any
surface – risk of fire!
Do not use the device if there is any visible damage to the housing, wire, switch, charge port or
cables. Take care when using a USB plug adaptor, check for any damage. Do not exceed 5V 2.1A
charging input or damage may occur to the batteries.
The rechargeable batteries will reach full performance after a few complete charging and
discharging cycles.
To keep the rechargeable batteries in optimum condition, they should be recharged every 3-6
months, especially if not being used for a long period of time. Always fully charge batteries before
storage and remember to remove batteries from head torch before storage to avoid battery
depletion.
ONLY USE HIGH-QUALITY 18650 LI-ION BATTERIES WITH OVER CHARGE PROTECTION
OTHERWISE DAMAGE MAY OCCUR TO THE HEAD TORCH.
Always protect lithium batteries from heat, intense sunlight, fire, water and moisture – danger of
explosion!
If a battery is damaged, fluids can leak out. AVOID contact as this can lead to skin irritation and/or
burns. If skin contact occurs, rinse thoroughly with water. If irritation persists, seek medical advice.
Seek immediate medical assistance if battery fluid comes into contact with the eyes.
Children under 12 years of age should only use the product under adult supervision.
Do not open, disassemble or attempt to modify the product; this will void the warranty and can be
dangerous. Improper use or modification is not covered under the warranty.
Take care not to let the lens come into contact with hard/sharp objects, damage to the lens will
affect light output.
This product is water resistant to IPX6 – DO NOT SUBMERGE.
If the product has been affected by damp, remove the batteries and leave the unit open and allow
to dry out completely before using. If the batteries are installed and the headlight does not work,
try checking for the following: (1) Operate the switch several times. (2) Check that the batteries are
inserted the correct way around according to polarity markings. (3) Check there is no debris on
the contacts that might affect the battery connection. (4) Check there is no water or dampness in
the light, if so, allow it to fully dry out and try again.
If the product has been subjected to excessive moisture/water the warranty may be void.
This product has a 1 year standard warranty (or extended to 2 years once registered online at
WWW.UNILITE.CO.UK/WARRANTY) against manufacturing faults and defects. It does not cover
normal wear and tear, modifications, accidental damage or poor maintenance. Unilite warranties
do not cover battery leaks or the use of incorrect chargers and cables that can damage batteries.
Do not dispose of this device in normal household waste. It must be disposed of via an authorised
disposal centre or at your local waste disposal unit.
Please reuse or recycle packaging where possible. Keep these instructions for future reference
or for subsequent possessors.Please reuse or recycle packaging where possible. Keep these
instructions for future reference or for subsequent possessors.
HL-11R
OPERATION
FLOOD BEAM SCREEN
CHARGING
1. Only use a 5V USB-C cable (max 2.1A)
2. Lift the charging port cover on the bottom of the battery pack.
3. Plug the USB-C end of the cable into the charge port.
4. Plug the USB-A end of the cable into any USB charging port (do
not exceed 5V 2.1A charging input or damage may occur).
5. 5 x Blue LEDs will flash to indicate charging status. All 5 LEDs
will light up constantly to confirm the batteries are fully charged.
6. Charge Time: 4½ hrs
**Warranty void if not used with the specified cable & max input**
ANSI FL1 Standard
15
Lumens
22M
148H
1100
Lumens
167M
4H
HIGH
LOW
*these runtimes are based on using 2 x 2600mAh li-ion 18650 batteries. Using 1 battery will
reduce runtimes. Using higher/lower mAh batteries will increase/reduce runtimes.
Twist switch to turn on
the headlight
1100
Lumens
Smooth Twist
Dimming Operation
low-to-high
15
Lumens
Power & Recharging
Indicators
USB Type-C
95%-100%
65%-95%
35%-65%
15%-35%
<15%
Recharging indicator
95%-100%
65%-95%
35%-65%
15%-35%
<15%
Power indicator
