Full product range & more information:
www.lumenalights.com
45mm
165mm
70mm
60mm
110mm
INSTRUCTIONS
AlvaLED MR16 TWIN Spike Light
–
12v Plug & Play
All finishes
WARNINGS
PLEASE READ THESE INSTRUCTIONS CAREFULLY PRIOR TO INSTALLATION / MAINTENANCE
•
If a fitting is found to be damaged, cease use immediately.
•
This is a Class 3 product (Low Voltage)
–
no earth required.
•
12V TRANSFORMER REQUIRED
–
sold separately
•
This unit must be fitted by a competent and qualified electrician.
•
Install in accordance with IEE wiring regulations and current Building Regulations.
•
To prevent electrocution, switch off mains supply before installing or maintaining this fitting. Ensure other persons
cannot restore the electrical supply without your knowledge.
•
This light fitting should be connected to a circuit with a 30Ma RCD fitted. Maximum 12-15 fittings on each circuit
recommended
–
varies based on total cable run.
•
If replacing an existing fitting, make a careful note of the connections.
•
All connections should be made as watertight as possible to avoid electrical shortage.
•
When changing the bulb, always switch off at the mains & allow the bulb to cool before handling
–
LAMP WILL GET HOT
WHEN IN USE
.
•
Always use the correct type & wattage of bulb. Never exceed the wattage stated.
•
The unit may get warm whilst on for a period of time.
•
12v Lighting must be wired in parallel, not series, and cable lengths kept to a minimum.
•
DO NOT PUT PRESSURE ON THE HEAD OF THE PRODUCT
SILICA GEL & O-RINGS (DO NOT REMOVE):
A small pack of silica gel has been included with this spike light, located inside the heads with the bulb holder. This should
not
be removed. Condensation inside the spike light is inevitable due to the heat generated from lamps and cold weather conditions,
especially if installed on a damp day. The pack of silica gel will collect the moisture inside the fitting, preventing this. It is
recommended that the silica gel is replaced when the light bulb is replaced, if not before, and the white rubber o-ring checked.
This fitting should not be used if there are any signs of damage.
CLEANING:
Occasional cleaning and care is recommended for this product. Please refer to our website for the best way to clean different
materials.
RETURNS & DISPOSAL:
If purchased from a 3
rd
party, please contact your supplier.
If purchased direct, contact us by phone or email:
Lumena Lights Ltd, Centre 33 Long March, Daventry, NN11 4NR Tel: +44 1327 871161 Email: [email protected]
Our full returns policy is available on our website.
Waste Electrical Products should not be disposed of with household waste.
Please check with your local authority or
contact us for more information. Please recycle packaging when possible.
Producer Registration Number: WEE/KC3440XY
Voltage:
12v (low voltage)
Max Wattage:
20w per spotlight
Bulb Holder:
MR16 x 2
IP Rating:
IP65
Cable Length:
2 core rubber cable 0.75mm (approx. 2m) per spotlight
Head:
Adjustable
Materials:
Aluminium & Tempered Glass
Finishes:
Black (Powder Coated) / Titanium & Cocoa (Anodised)
Mount:
4 fin ground spike with 40cm pole
Included:
2 x Spotlights, riser pole, ground spike, allen key, 2 x cable ties
✔✔✔
3 YEAR
GUARANTEE
see website for
more details
400mm
