www.ultralegs.com
1
Ultra Legs
®
Tri-Toon
Installation Guide
3006.4611
Ultra Legs
®
are a hydraulic leg lift that attaches to your pontoon, giving you the freedom and
range to take your lift anywhere you can take your pontoon. The Twin-Tube model operates
with two sets of legs, each set is strengthened by a reinforced crossbar and holds a sturdy
footpad. The Tri-Toon model comes complete with four separate legs. When not in operation,
the legs nestle within inches of the deck of your pontoon, invisible to the unknowing eye, yet
when operating, Ultra Legs
®
gives your boat up to six feet of lift, keeping it safe, secure and out
of the water in nearly any shallow water situation. Rocks, muck, wind and current are no match
for your new lift. Welcome to Ultra Legs
®
.
CAUTION:
Installation of Ultra Legs
®
should be done only by trained and authorized professionals, needs
a minimum of two people and requires access to the underside of the pontoon receiving the
Ultra Legs
®
. Under no circumstances should installation be attempted in water as severe injury,
drowning or death may occur. Install only in a well-lit area on a hard, flat surface. Ultra Legs
®
require at minimum six feet above and in front of your pontoon to check product operation
during installation. Always wear appropriate protective equipment.
Do not begin installation until these requirements have been met.
Equipment Checklist:
Included in your Ultra Legs
®
package should be the following:
• Ultra Legs
®
Power Unit and Remote Control (1): 2.5 HP, 12VDC, uni-rotational electric motor for
raising and retracting lifting leg cylinders.
• Ultra Legs
®
Leg Component (4): Leg Components with 3500 psi and solid steel Hydraulic
Cylinder construction.
• Ultra Legs
®
Oil
o 2.5 Gallon Bottle (1): Used for initial installation.
o 1 Gallon Bottle (1): Used for initial installation.
• Ultra Legs
®
Installation Kit
o 360” Hydraulic Hose (1)
o 252” Hydraulic Hose (2): Purple, Purple/Brown
o 192” Hydraulic Hose (3): Orange, White, Orange/White
o 96” Hydraulic Hose (2)
o 28.5” Hydraulic Hose (2)
o 12” Hydraulic Whip Hose (4)
o 15’ Battery Cables (2): Red, Black
o 5/16” x 1” Zinc-plated Hex Lag Screw (4)
o 5/16 – 18 x 1” Hex Cap Bolts (56)
o 5/16 – 18 Flange Lock Nut (56)
o #8 x 1” Stainless Steel Screws (9)
o Cable Tie with Eye (5)
o Cable Tie without Eye (10)
o T-Fitting (2)
o 90° Fitting (8)
