Wrap the belt around the pulley groove. Then hold the
belt along the platter’s back edge with your right hand.
Keeping your right hand in place, use your left hand to
guide the belt around the edge of the platter.
To change speeds, move the belt to the top pulley
groove (33 RPM) or bottom groove (45 RPM).
The belt should be relatively loose – this helps prevent motor
vibrations from reaching the stylus and minimizes platter speed
variation. Avoid pulling on the belt or pulley during installation.
2
Belt installation and changing speeds
3
Removing the stylus guard
Orbit Turntable
Setup Guide
1
Initial setup
Place the platter on the center spindle.
Slide the dust cover onto the hinges.
Connect the power adapter to the jack on the back of your Orbit.
Connect to your sound system using the included RCA cables.
For Audio-Technica, Grado,
and Ortofon OM5E:
Pull cover forward until it slides off.
For Ortofon 2M
Red and Blue:
Pinch tab then pull
cover down.
A
A
A
A
B
B
B
B
C
C
C
C
D
D
