1011 IH-840U-10
PAGE 1 OF 2
PARTS
ASSEMBLY
9
⁄
16
" Wrench (2)
7
⁄
16
" Wrench or Socket
A. Side Handrail (1)
C. Rear Handrail Bar (1)
(shipped under a step
attached with orange ties)
B. Side Handrail (1) Opposite
Handrail Brackets
(shipped attached to side of Stile)
Notched Bushings (4)
D. Stile (1)
F. Back Panel (1)
Hardware Kit (1)
(misc. hardware included)
E. Bottom Bars (2)
TOOlS NEEDED
WARNING! Assembly of these types of ladders
can be inherently dangerous. Please take all
precautions necessary during the assembly
process. Always use a separate ladder to
finish assembly in high places. Never climb a
ladder that is not completely assembled. Do
not assemble or use a ladder with missing or
damaged parts. Use proper lifting mechanics
when assembling a ladder. Watch for overhead
electrical hazards and obstructions.
STEP 1: BACK PANEl ASSEmBly
NOTE: DO NOT tighten bolts until instructed to.
1. Place the ladder stile (D) on the floor. Be sure to
assemble on a protective surface so the finish does
not get damaged.
2. Bolt back panel (F) to the insides of lugs 1 with (2)
3
⁄
8
-16 x 1¼" hex head cap screw and self-locking
nuts. (See Figure 1)
Rubber mallet
Safety Glasses
H-840U-10
H-1082U-10
3-4 STEP ROLLING
SAFETY LADDERS
10" DEEP TOP STEP
