![background image](http://html1.mh-extra.com/html/u-line/h-5784/h-5784_quick-start-manual_3132358001.webp)
PAGE 1 OF 3
0716 IH-5663
π
H-5784
FLOOR SAFE
1-800-295-5510
uline.com
TOOLS NEEDED
HARDWARE INCLUDED
Drill
70mm Lag
Screw x 2
Washer x 2
40mm Plastic Anchor
x 2
7/16" Drill Bit
3/8" Drill Bit
Phillips Screwdriver
17mm Wrench
USAGE
IMPORTANT! Record the serial number from the
tag on the back of the safe or from the tag on
the front bottom corner of the safe.
Keep keys and combination in a secure place,
away from children.
Do not store the backup key, your combination
or this document in the safe.
WARNING! Keep your safe closed and locked
at all times when not in use. Children could
accidentally be locked inside the safe.
Do not move this safe using its handle. The
handle should only be used for opening and
closing the door of the safe.
Do not store electronic media, computer disks,
audio-visual media or photographic negatives
in this safe. This material will not survive the
rated internal temperature of the safe. This
material may be damaged or destroyed.
BATTERY INSTALLATION
1. You must first install the battery, which is located in
the front protective styrofoam.
NOTE: When changing the battery, always
hold the battery connecting cap while
disconnecting or attaching the battery. Do not
pull on the wires. Doing this could cause the
power supply to become disconnected from
the lock.
2. This safe uses one 9V alkaline battery.
3. When the battery is low and you press a button on
the keypad, a red light will come on warning you
that the battery is low.
4. To replace the battery, remove the cover by pressing
the tab and turning the cover. (See Figure 1)
5. Replace the old battery and screw the cover back
in place.
ELECTRONIC LOCK
1. After installing the battery, to open an electronic
lock the first time, press the following numbers/
symbols on the electronic keypad in this order:
1-5-9-#. These numbers are preset.
NOTE: You should change the entry code as
soon as possible after opening the safe to
ensure proper security.
2. After you have entered the factory code, you will
need to turn the handle clockwise to open the door.
You will have 5 seconds to turn the handle before
the locking mechanism is reactivated.
Figure 1