![background image](http://html1.mh-extra.com/html/u-line/h-1276/h-1276_manual_3108275001.webp)
PAGE 1 OF 6
0621 IH-1276
H-1276, H-1981
AUTOMATIC LABEL
DISPENSER
1-800-295-5510
uline.com
OPERATING INSTRUCTIONS
1. Pull photo eye away from unit approximately 2½" or
so and turn on motor. Move sensor back and forth
with finger to observe how it turns motor on and off.
Shut motor off.
2. If label roll has 3" core, install core inserts in each
side of roll – place on roll holder rod (M) at rear and
tighten locking collar with thumb screw into position
against core insert to hold roll and other core insert
against side collar and side plate of unit.
3. If label roll has smaller core diameter, mount first
core insert on rod (M) with flange against dispenser
side plate, then slide roll of labels on rod, install
second core insert against roll and then lock collar
with thumb screw.
4. Pull leading edge of carrier paper web under the
first chrome bar then between the next chrome bar
(C) and plate (D) and back around plate, down
toward take-up spool. (See Figure 1)
5. About 5" of carrier paper is needed for a leader for
dispensing operation. Attach leader to take up spool
by pulling clip "I" off of spool and then sliding the clip
back on over the leader – leader is now engaged.
6. Adjust side guide (A) flush against web, with left
edge of print-out web about 1/8" from side plate of
dispenser.
7. Position photo eye to shut off motor just as rear of
label emerges from under rod (C). You should be
able to just see the end of the label. If the label is
permitted to advance too far, it can fall off web or
may continue down on the web without being seen
by the photo eye sensor. Adjust eye position for
smooth operation of unit as labels are removed.
8. FOR NARROW LABELS: Factory setting of the switch
accommodates labels 1¼" wide or larger. For
narrower labels, adjust lateral switch setting by
removing one or more of the spacers on the
unit. (See Figure 2) To do this, remove lock nut
and remove button head screw with a small
Allen wrench. Remove spacers until photo eye
is positioned in the center of the label. Tighten
assembly against the side plate. Replace and
tighten lock nut.
Roll
of labels
Roll holder
retainer plate
M
C
D
CLIP
Switch
Label
Photo Eye
Take-up
spool
I
A
Figure 1
D
M
A = Lock nut
C = 1/8'' Spacer
D = 1/4'' Spacer
M = Round head
button screw
C
A
Figure 2
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.