D-307164 MP-902 PG2 Installation instructions
1
1. Overview
The MP-902 PG2 is a smart, wireless outdoor curtain PIR detector with
anti-masking. It is supported by the PowerMaster alarm system and uses
PowerG two-way communication protocol.
The detector has the following features:
l
l
l
l
l
l
l
l
l
l
l
l
l
l
Two
channel
Pyro
(patented)
thermal
sensor
output
Microprocessor-controlled
temperature
compensation
White
light
protection
Adjustable
pet
immunity
selector
with
three
options:
no
pet,
a
small
pet
weighing
less
than
3
kg
or
6.6
lb,
or
a
pet
weighing
less
than
18
kg
or
40
lb.
Adjustable
detection
sensitivity
Parabolic
and
elliptical
optics
(patented)
Target
Specific
Imaging™
(TSI)
technology
distinguishes
between
humans
and
pets
weighing
up
to
18
kg
or
40
lbs
True
Motion
Recognition™
algorithm
(patented)
distinguishes
between
the
true
motion
of
an
intruder
and
any
other
disturbances
which
may
cause
false
alarms.
Cross-direction
detection:
both
directions,
left
to
right,
and
right
to
left.
Active
smart
anti-masking
ability
recognizes
spray
and
dust
(patented)
No
vertical
adjustment
is
needed.
Long-life
battery
which
is
due
to
the
ultralow
current
consumption
Front
and
back
tamper
protection
(patented)
Supports
temperature
and
light
level
reports
according
to
the
PowerG
panel
version
Note:
For UL installations, only use the device with UL listed control units.
Figure 1: MP-902 PG2
1. Bracket
2. Detector
3. Indication LED
4. PIR optical window
2. Installation advice
Qualified service persons only can install the MP-902 PG2. Before you install the device, consider the following points:
l
Install the MP-902 PG2 according to the Standard for Installation and
Classification of Burglar and Holdup Alarm Systems, UL 681.
l
Mount the detector so that the expected movement of the intruder will
cross the PIR beam.
l
Mount the device on a vertical surface and as straight as possible.
l
Mount the device upright. See Figure 2.
l
Direct the detector at a stable surface, such as a wall or fence, to
provide a curtain detection boundary for better detection.
l
Mount the device at a height that agrees with your pet immunity
preference. See
for more information.
l
Consider weather conditions that can trigger false alarms, such as
moving tree branches or leaves, and other related environmental
conditions
l
Locate the device at least 20 cm from all persons during normal
operation to comply with FCC and ISED Canada RF exposure
compliance requirements
l
Install the device over sloped ground. See Figure 3.
l
Install the device close to tree branches as weather conditions can
cause movement, resulting in false alarms
l
Install the device in hazardous locations
l
Install the device in areas with a pollution degree higher than pollution
degree 2
l
Install the device in circuits above overvoltages category II
l
Obscure the field of view of the detector
l
Co-locate or operate the antennas used for this product in conjunction
with any other antenna or transmitter
l
Mount the device on surfaces where surface vibration can occur
Figure 2:
Mounting orientation
Figure 3: Flat ground installation
MP-902 PG2
Wireless outdoor curtain PIR detector with anti-masking and pet immunity
Installation instructions
Do:
Do
not:
