Thank you for choosing the Vibra-Tector 740
metal detector made by Treasure Products, Inc.
The unique sealed design allows detecting in any
environment including grass, mud, dirt, sand,
black sand, or even in fresh or salt water to a
depth of 100 feet (30 meters).
Pulse Induction Metal Detector
Product Features
Communicates with vibration & light
When a target is located the Vibra-Tector 740
signals with pulses of vibration and flashes of
bright light from a white LED.
Pulse Induction Technology (PI)
A specialized type of detection technology that
allows hunting in salt water or in any type of soil,
including black sand.
Detection depth stability
Advanced electronic circuitry maintains detection
distance throughout the life of the battery.
Target distancing
As you get closer to the target the pulses of
vibration and light will increase in quantity
.
Automatic tuning
The state-of-the-art microprocessor controlled
design requires no adjustments of any kind.
Waterproof to 100 ft (30m)
The detectors sealed design allows hunting in the
rain or under water to a depth of 100 feet.
Battery Installation
Understanding the Compartment Seal
This detector uses a compression plug to seal the
battery compartment. When the knob of the seal
is rotated clockwise, the rubber in the plug
expands and presses against the inside wall of
the battery compartment, sealing the unit.
Opening the compartment
To open the battery compartment seal, rotate the
knob counter-clockwise a few turns, then pull to
remove.
Connecting battery
Connect a standard 9-volt battery to the battery
clip and insert the battery into the detector, clip
side first.
Sealing the compartment
To replace the seal, insert all the way in. Then
turn the knob clockwise until hand tight to assure
a water-tight seal.
Before submerging detector make sure
the battery compartment seal is secure.
Operating Instructions
Power on
Hold unit with the search coil up. Light will flash.
Two short pulses of vibration, and a steady dim
light, indicate unit is on.
Power off
After use, hold unit with the search coil up. Light will
flash. Two long pulses of vibration, and no light,
indicate the unit is off.
Low battery auto-off
When the battery is low the unit will shut down
automatically indicated by four long pulses of
vibration and bright light.
Detecting a Target
The Vibra-Tector communicates through pulses
of vibration and bright light. These pulses
increase in quantity the closer the search coil is
to a detected target.
The quantity of pulses is proportional to the target
size and distance. The bigger the target, or the
closer the search coil is to the target, the higher
the pulse count.
Movement of the search coil is required to detect
a target. Sweep the search coil back and forth
along the surface you are searching.
The detector communicates its proximity to the
target only one time per detection. Move the coil
slightly away and then re-approach the target to
get the next detection.
Made in USA
Treasure Products Inc.
www.TreasureProducts.com
Vibra is a registered trademark of Treasure Products Inc.
Use only high quality batteries such as
alkaline or nickel metal hydride (NiMH).
740
Vibra-Tector
Continued on back
