![background image](http://html.mh-extra.com/html/totally-wicked/tornado-ex-edge/tornado-ex-edge_user-manual_1139167001.webp)
USING YOUR TORNADO EX EDGE
Note: It is important to “prime” a new atomizer head before first use. Failure to
do so can cause the atomizer coil to overheat, leading to an unpleasant taste
and sometimes irreversible damage to the atomizer head.
Priming the Atomizer Head
Remove the cartridge from the Tornado EX Edge by pulling straight out. Invert the
cartridge and unscrew the atomizer base. Keep the atomizer head attached to the
base. Drip a few drops of e-liquid on each of the four e-liquid inlets on the side of the
atomizer head, and into its central hole to fully wet the wicking material.
Filling the Tank
With cartridge removed, locate the rubber flap on the side of the cartridge, and lift
the edge marked with a droplet symbol. With the filling port now exposed, insert
your e-liquid bottle nozzle fully, and fill to leave a minimum air gap of approximately
2mm. Close the flap and reinsert the tank firmly into the Tornado EX Edge.
Note: After priming a new atomizer head and filling the tank, it is recommended
to wait 5 minutes to ensure the atomizer head is fully saturated.
Power On and Off
To turn the device on or off, simply press the power button 5 times.
The LEDs will flash quickly 3 times to confirm that the on-off state has changed.
Vaping
Press and hold the power button as you inhale the vapour. The LEDs at the bottom
of the device will illuminate while the power button is held down to vape.
Battery Level Indication
Approximately one second after the power button is released, the LED will relight to
show the battery’s approximate remaining charge as detailed in the table below.
CONGRATULATIONS ON PURCHASING YOUR
TOTALLY WICKED TORNADO EX EDGE KIT
Battery Level
Light Condition
100%-60%
Stays lit for 5 seconds
59%-30%
Flashes slowly
29%-10%
Flashes at a moderate speed
9-0%
Flashes rapidly
Cartridge Filling port
Atomizer base
LED
Atomizer head
USB charging port