USING YOUR AIO 2
Priming and installing the atomizer head
Note: It is important to “prime” a new atomizer head before first
use. Failure to do so can cause the atomizer coil to overheat,
leading to an unpleasant taste and sometimes irreversible
damage to the atomizer head.
To install an atomizer head, unscrew the cap assembly by
pushing down on the airflow control ring, and turning anti-
clockwise. Prime one of the atomizer heads provided by dripping
a few drops of e-liquid into the centre of the atomizer head.
Screw the atomizer head onto the cap until firmly seated. Fill the
tank as directed in the following instructions.
Filling the tank
To fill the device, simply remove the cap assembly and fill the
tank, being careful not to exceed the designated max fill line.
Screw the cap assembly back into the tank.
NOTE: It is important not to fill beyond the max fill line,
as this will cause e-liquid to overflow when the cap assembly
is installed.
NOTE: After priming a new atomizer head and filling the tank,
it is recommended to wait 5 minutes to ensure the atomizer
head is fully saturated.
Changing the atomizer head
To change the atomizer head, unscrew the cap assembly.
Unscrew and dispose of the old atomizer head. Prime the
new atomizer head and refit following the directions in
Priming and installing the atomizer head.
Power on and off / Changing the tank LED colour
To turn the device on or off, quickly press the power button
5 times. The LED will flash 5 times quickly to confirm your
selection.
To change the colour of the LED displayed in the tank, turn the
device off and hold the power button until the LED illuminates.
Then press the power button repeatedly to cycle through the
colours: blue, green, indigo, red, purple, yellow, white, or no
light. Release the power button to confirm your selection.
Vaping
Press and hold the power button as you inhale the vapour. The
LED will illuminate while the power button is held down to vape.
Charging the battery
To charge the battery, connect the charge lead to the USB
port. The LED at the bottom of the tank will glow red and
simultaneously flash 5 times in your chosen colour when the
charge lead is first connected. Once charging, the LED will
continue to glow red until fully charged, at which point it will
turn off.
USER MANUAL
CONGRATULATIONS ON PURCHASING YOUR
TOTALLY WICKED AIO 2 ELECTRONIC CIGARETTE KIT
Cap assembly
Mouthpiece
Atomizer head
Power button
USB port
All-in-one battery and tank
Airflow control ring
USB port
