PROGRAMMING THE REMOTE CONTROL
l
This Remote Control is preprogrammed to operate TOSHIBA
l
To use VCR’s other than Toshiba models (or Cable converter), perform the following procedures before operating.
CH
TO CONTROL OTHER BRANDS OF VCR’S AND CABLE
TV
CONVERTERS
Refer to the
VCR code table”
(or “Cable
code table”)
on
pages 16 and 17 to find the code number that corresponds to the
brand name of your VCR (or your converter).
RECALL
If more than one number is listed, try each one separately untit you
find the one that works.
N u m b e r
Set the
switch to VCR (or CABLE).
Hold d own RECALL while pressing the
Number
buttons for the three
digit code number for your brand of VCR (or converter).
The transmit indicator tights up for second when the programming
is completed.
When an operation error has occurred, the indicator blinks.
Press
RECALL
again to reset.
Point the Remote Control at the VCR (or at the converter) and press
POWER to test the code number.
If the right number was entered,
the VCR should turn on.
the VCR does not respond to the Remote Control,
repeat steps
1
to 4 with another code number.
Notes:
l
You have to reprogram the Remote Control when you change its
batteries.
Some newer VCR’s are capable of working on either of two remote
codes. These VCR’s have a switch labeled
If your VCR has this kind of switch, and does not respond to
the code
numbers for your VCR brand name, set the switch to another position
or “VCR2”) and reprogram the Remote Control.
For future reference, write the
code you used.
VCR CODE:
CABLE CODE:
2
i=
E
