Toro TITAN ZX 74846, Setup Instructions

Page: 1 / 8

Form No. 3394-403 Rev A
TITAN
®
ZX Riding Mower
Model No. 74846—Serial No. 315000001 and Up
Model No. 74848—Serial No. 315000001 and Up
Setup Instructions
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
1
No parts required
–
Connect the battery.
Rear hitch 1
Bolt (5/16 x 2-1/2 inches) 2
2
Locknut (5/16 inch) 2
Install the rear hitch.
3
No parts required
–
Set up the motion-control levers and the
seat.
Rollbar 1
Rollbar support 2
Reinforcing bracket 2
ROPS plates 4
Bolt (1/2 x 3–1/2 inches) 10
Bolt (1/2 x 4–1/2 inches) 2
Hex locknut (1/2 inch) 8
Flat washer (1/2 inch) 8
Thrust washer 4
Flange locknut (1/2 inch) 10
Bolt (5/16 x 3–3/4 inches)
2
Flange locknut (5/16 inch, may be
pre-installed)
2
4
Flat washer (5/16 inch) 2
Install the Roll Over Protection System
(ROPS).
5
No parts required
–
Check the mower adjustment.
Ignition key 1
Operator's Manual 1
6
Engine Operator's Manual 1
Complete the setup.
Note:
Determine the left and right sides of the machine from the normal operating position.
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN)
Printed in the USA.
All Rights Reserved
*3394-403* A