Form No. 3390-719 Rev A
Solenoid Controller Kit
Workman
®
HDX-Auto Utility Vehicle
Model No. 131-8308
Installation Instructions
WARNING
CALIFORNIA
Proposition 65 Warning
This product contains a chemical or chemicals known to the State of California to
cause cancer, birth defects, or reproductive harm.
The purpose of this kit is ad add a solenoid controller
to the electrical system. The solenoid controller is used
to automatically modulate the current to the differential
solenoid.
Preparing to Install the Kit
1.
Move the machine to a level surface and set the parking
brake.
2.
For machine models with a utility bed, perform the
following:
A.
Raise the bed until the lift cylinders are fully
extended; refer to the
Operator’s Manual
for the
machine.
B.
Remove the bed support from the storage
brackets on back of the ROPS panel (
).
Figure 1
1.
Bed Support
C.
Place the bed support onto the cylinder rod,
making sure that the support end tabs rest on the
end of cylinder barrel and on the cylinder rod end
(
).
Figure 2
1.
Bed support
3.
Bed
2.
Cylinder barrel
3.
Shut off the engine, set the parking brake, and remove
the key from the ignition switch.
4.
Disconnect the battery as follows:
A.
Squeeze the battery cover to release the tabs from
battery base (
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3390-719* A
Summary of Contents for 131-8308
Page 4: ......
