2003—The Toro Company
8111 Lyndale Ave., Bloomington, MN 55420, USA
Printed in the USA
All Rights Reserved
Original Instructions (EN)
Snow Cab Kit
Power Max
Snowthrowers
Model No. 107-3814
Form No. 3351-212
Installation Instructions
Save these instructions with your Operator’s Manual for
future reference.
Installing this snow cab onto a Power Max
snowthrower without properly installing a
counterweight to the front of the snowthrower can
cause it to tip backward and fall on the operator,
causing injury.
•
Do not operate a snowthrower with a snow cab
that does not have the proper counterweight.
•
Obtain and install a Toro weight kit to the front
of the snowthrower in order to balance the
added weight of the snow cab.
Warning
Contents of the Kit
DESCRIPTION
QUANTITY
U-brackets
2
Washers
4
End caps
2
Headlight extension bar
1
Bolts, 1/4 x 1 in.
2
Bolts, 1/4 x 3/4 in.
6
Bolts, 1/4 x 1-3/4 in.
2
Locknuts, 1/4 in.
10
Bolt, 5/16 x 3/4 in.
1
Flange locknut, 5/16 in.
1
Top frame
1
Rear frame
1
Horizontal frame
1
Left mounting bracket
1
Right mounting bracket
1
Front posts
2
Cover
1
Installing the Snow Cab Frame
on the Snowthrower
1. Remove the 2 upper handle nuts (1 on each side) from
the snowthrower handle assembly (Fig. 1) and save
them for step 2.
m-7249
1
2
3
4
5
6
Figure 1
1.
Handle assembly
2.
Upper handle nut (2)
3.
U-bracket (2)
4.
Bolt, 1/4 x 1-3/4 in. (2)
5.
Locknut (2)
6.
Left mounting bracket
2. Install the lower front end of the left and right
mounting brackets onto the handle assembly using the
upper handle mounting nuts you removed in step 1
(Fig. 1).
3. Install the other lower end of each mounting bracket
onto the handle assembly with a U-bracket, bolt (1/4 x
1-3/4 in.), and locknut (Fig. 1).
Note: You may need to squeeze each U-bracket together
slightly before installing it onto the handle assembly.
Note: The ends of the U-brackets should face downward.
