1
All Rights Reserved
Printed in the USA
2001 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Canopy Kit
Workman
1100/2100 and Twister
Utility Vehicle
Model No. 07297
Model No. 07297R
Form No. 3326-769 Rev B
Installation Instructions
Safety and Instruction Decals
Safety decals and instructions are easily
visible to the operator and are located near
any area of potential danger. Replace any
decal that is damaged or lost.
104-6731
Assembly
1. Position the machine on a level surface. Set the parking
brake, turn the ignition off, and remove the key.
If you leave the key in the ignition switch, someone
could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the ignition switch before
you do any maintenance.
Caution
2. If your vehicle has a Roll Over Protection System
(ROPS), proceed to step 3. If your vehicle does not
have a ROPS, proceed as follows:
A. Loosely attach the support brackets to the rear
support tube with 8 screws, 4 (5/16 x 2-3/4 in.) and
4 (5/16 x 1-3/4 in.); 16 flat washers (5/16 in.); and 8
flange nuts (5/16 in.) (Fig. 1).
B. Loosely attach the support brackets to the vehicle
with 8 screws (5/16 x 1 in.), 16 flat washers
(5/16 in.), and 8 flange nuts (5/16 in.) (Fig. 1).
3. Remove the rear bolt that holds the front fender to the
dash and front frame support on each side of the
vehicle. Do not remove the fenders from the vehicle
(Fig. 1).
1
2
3
4
5
6
7
8
9
Figure 1
1.
Rear support tube
2.
Left-hand support bracket
3.
Screw, 5/16 x 2-3/4 in.,
and washer, 5/16 in.
4.
Screw, 5/16 x 1-3/4 in.,
and washer, 5/16 in.
5.
Flange nut and washer,
5/16 in.
6.
Screw, 5/16 x 1 in,. and
washer, 5/16 in.
7.
Left-hand front fender
8.
Right-hand front support
9.
Left-hand front support
