AC ULTRA Plus
Air-Conditioner Remote Control User’s Guide
Product Description
The AC ULTRA PLUS is the leading replacement A/C remote control in Australia.
With over 1,000 codes it is compatible with 99% of the air conditioners sold in Australia.
It is simple and easy to program and will include many of the features of you original
remote
Need support? Ring Thermo Controls Mon-Fri 9am-5pm on 03 8899 6272. You can
also scan the QR code on the front for the latest codes.
Instructions to program your remote control with your air conditioner (A/C)
1. Open the battery cover and insert two AAA (UM-4 or R03) batteries.
2. Find you’re A/C code brand on the back of these instructions. If there is more that
one code for one brand, you will have to try them one by one. E.g. for FUJITSU,
try model codes 0127 to 0137 then 0464 etc. Next, lift the front cover.
3. To Program your four digit code: Press and hold the
“SELECT”
key, the four digit
code on the LCD will begin flashing. Press “
CODE” - or +
until required brand
code appears. Then press the
“ENTER”
key, the brand code stops flashing.
Aim the remote at the A/C and press the
“POWER”
key, your remote is
programmed and you can control your air conditioner. If not, select the next code
from the table and test again.
Brand not listed? Code you have tried did not work? DON’T PANIC
If you don’t know the brand of your air conditioner, you cannot find your brand on the
list or the codes you tried don’t work? Don’t worry, there is probably a code in the
remote that will get you’re A/C working. Please follow these steps:
1. Press and hold the
“SELECT”
key, the four digit code on the LCD will begin
flashing. Point the remote control at the A/C, begin pressing the
“SELECT”
key.
Continue to press the
“SELECT”
key. Every time you press the
“SELECT”
key
the remote is sending an infrared signal to turn on the A/C. Continue to press
the
“SELECT”
and eventually the remote will find a code to turn on your A/C.
You will hear a beep or the fan will turn on.
Be patient, it can take up to ten minutes to cycle through 1,028 codes. Alternatively
you can hold down the
“SELECT”
key for 5 seconds and it will cycle through itself.
This will take 20 minutes. After the A/C turns on, try other function keys. If they do not
work, repeat above steps finding the correct code. Write the number on the inside
cover if you need to refer back to it. If this fails, please contact us.
Switching between Celsius and Fahrenheit
Press TEMP UP and TEMP DOWN simultaneously.
Clock setting of remote control
1. Press the
“CLOCK”
key, the clock on LCD will flash.
2. Press
“TIME”
+ or -,
adjust to correct time. Time is in 24 hour format.
3. Press the
“CLOCK”
key again, your clock is now set.
