Page 1 of 2
Version: 1
1. Connect all sides of the frame using the hex screws and hex key provided,
but do not full tighten. Once all sides are connected, fully tighten all corners.
Note: -U units have uprights preattached to vertical frame sides.
2. Crossbar installation required for 96” high units ONLY:
Use the hex key provided
to loosen the end brackets fully, place the crossbar in the channel of the
frame, then tighten the end brackets to secure the crossbar in place.
3. Connect the base to the frame using the screws and nuts provided.
4. install the graphics per instructions shown on the next page.
Charisma SEG Epic Stand™ - XS Series
Roll-around - XSR
Mini Marquis - XSQ
Elliptical - XSE
XSE36 shown
XSE48 shown
Without uprights
With uprights (-U)
1. With Upright
Upright
pre-attached
1. Without Upright
1.
1.
1.
1.
2.
2.
2.
3. XSE
XSE-U
3. XSQ
XSQ-U
XSR-U
3. XSR48
