![background image](http://html1.mh-extra.com/html/teeter/conversion-bar/conversion-bar_assembly-and-user-instructions_1073632001.webp)
for Teeter Hang Ups
®
Inversion Tables
Conversion Bar
Assembly & User Instructions
PRE-ASSEMBLY
BEFORE YOU BEGIN:
These instructions will guide you in properly assembling and using the unit. Please review all the
steps before beginning assembly. Carefully adhere to these instructions to help ensure user safety and product integrity.
ASSEMBLY
Step One: Remove the Rear Bar
• Remove a black plug and one rear foam ankle clamp with backing from the same side
of the rear bar (Figure 1).
• Remove the nut and bolt; slide the rear bar out from the main shaft. Keep the nut and bolt
in case you want to re-attach the ankle clamps in the future.
Step Two: Remove the Front Ankle Clamps
• Remove the bolt that holds the retainer spring attached to the front ankle clamp (Figure 2).
*Keep the bolt and nut for use in Step Three.
• Pull up on the locking pin and remove the front ankle clamp assembly and spring.
Step Three: Install the Conversion Bar
• Insert the Conversion Bar into the ankle clamp housing.
• Attach the Conversion Bar by inserting the bolt removed in Step Two through the holes
located at the front of the ankle clamp housing underneath the T-Pin (Figure 3).
• Tighten the nut and bolt with the wrenches provided with your inversion table.
• With the Conversion Bar in place, you may choose to remove the locking pin by unscrewing
its base.
Be sure to keep it in case you want to re-attach the ankle clamps in the future.
Figure 1
Figure 2
Figure 3
PURPOSE:
Some users prefer to use the standard ankle clamps provided with the Teeter Hang Ups Inversion Table.
Others prefer to use the Teeter Hang Ups Gravity Boots while inverting. To convert your inversion table for use with
Gravity Boots, you
must install the Conversion Bar - failure to do so could result in serious injury or death.
Please carefully comply with the following instructions:
WARNING
!
It is your responsibility to familiarize yourself with the proper use of the equipment and the inherent risks of inversion, such as falling on your
head or neck, pinching, entrapment or equipment failure. FAILURE TO FOLLOW INSTRUCTIONS OR HEED WARNINGS COULD RESULT
IN SERIOUS INJURY OR DEATH.
Restrictions on Use
•
DO NOT
attempt to use the Conversion Bar with any other inversion table that is not designed specifically to be adapted with the
Conversion Bar. The Conversion Bar is to be used only with certain Teeter Hang Ups model inversion tables. Check with the manufacturer
if you are unsure whether or not your inversion table can be modified with the Conversion Bar.
Precautions During Assembly and Before Use
•
ALWAYS
choose a level surface for assembling the Conversion Bar and operating the inversion table.
• Follow each step in sequence.
DO NOT
skip ahead.
•
DO NOT
use until you have thoroughly and carefully read all accompanying documents for the inversion table and Gravity Boots, reviewed
product labeling, and inspected the equipment.
•
ALWAYS
test and inspect the Teeter Hang Ups Conversion Bar, Gravity Boots and Inversion Table prior to use. Make sure the table
rotates smoothly to inverted position and back. Make sure that all fasteners are secure.
•
ALWAYS
replace defective components immediately and/or keep the equipment out of use until repair.
Precautions During Use
•
ALWAYS
wear the Gravity Boots when using the Conversion Bar, making sure the Gravity Boots are fastened securely around the ankles
and checking that the Gravity Boot Hooks are fitted properly around the Conversion Bar.
WARNING
!
Failure to assemble the Conversion Bar properly could result
in serious injury or death!