Vertical Pin Header
Right-Angle Pin Header
Plug Housing
Cap Housing
Latching
Arm
Latching
Ear
Locking
Latch
Printed Circuit (PC)
Board (Ref)
Locking
Tab
Wires
(Ref)
Wires
(Ref)
WIRE
CONTACT
SIZE RANGE
(AWG)
INSULATION DIAMETER
RANGE (mm [in.])
PIN
SOCKET
STRIP
LOOSE PIECE
STRIP
LOOSE PIECE
30-26
1.52 [.060] (Max)
794216-1
794224-1
794217-1
794225-1
794216-3
794224-3
794217-3
794225-3
26-22
1.19-1.75 [.047-.069]
794218-1
794226-1
794219-1
794227-1
794218-3
794226-3
794219-3
794227-3
22-18 or (2) 22
1.50-2.79 [.059-.110]
794220-1
794228-1
794221-1
794229-1
794220-3
794228-3
794221-3
794229-3
20-16
2.01-3.20 [.079-.126]
794222-1
794230-1
794223-1
794231-1
794222-3
794230-3
794221-3
794231-3
© 2012 Tyco Electronics Corporation, a TE Connectivity Ltd. company
All Rights Reserved
*Trademark
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or company names may be trademarks of their respective owners.
1 of 3
Instruction Sheet
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
408-3393
Mini-Universal MATE-N-LOK* 2
Connectors
20 JUN 12 Rev B
Figure 1
1. INTRODUCTION
This instruction sheet provides assembly and
disassembly procedures for Mini-Universal
MATE-N-LOK 2 connectors used in free hanging or
pc board applications.
Dimensions in this instruction sheet are in metric
units [with U.S. customary units in brackets].
Figures are not drawn to scale.
NOTE
i
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
2. DESCRIPTION
(See Figure 1)
The pin header is available in vertical and right-angle
configurations. The plug housing and cap housing
accept the contacts listed in Figure 1. The housings
are polarized for proper alignment when mating. Keying
plugs are available to provide additional polarization
when mating the connectors. Positive locking features
prevent accidental disengagement of mated connectors.
3. ASSEMBLY PROCEDURE
3.1. Inserting Contacts
1. Select the appropriate pin and socket contacts
from Figure 1. Terminate the contacts according to
Application Specification 114-1111.
2. Rotate the wire end (back) of the housing 180
degrees along the pivot track until the first tooth of
each latching arm engages — the housing is in the
open position. See Figure 2.
