INSTRUCTIONS FOR INSTALLATION
OF RADIO BOARD FOR (YE-RF-##)
TASK FORCE TIPS, Inc.
3701Innovation Way, Valparaiso, IN 46383-9327 USA
800-348-2686 • 219-462-6161 • Fax 219-464-7155
MADE IN USA • www.tft.com
©Copyright Task Force Tips, Inc. 2010
LIY-415 October 4, 2010 Rev00
Observe precautions for handling Electrostatic Sensitive Devices. Be
sure to touch unpainted, exposed metal on monitor or firetruck before
removing and handling circuit boards.
1) Turn off power and remove lid from monitor control box.
Unscrew the lid screws but do not remove screws completely
from lid. Be careful to open lid slowly as lid is connected to
communication board by a flat cable.
Securely support lid during the installation process.
2) Locate connector with blue &
white wires on the small
communication board on the far
left.
3) Unplug connector with blue &
w h i t e
w i r e s
f r o m
t h e
communication board.
Communication
Board
Lid
Screw
Lid
Screw
TASK FORCE TIPS
®
FIRE FIGHTING EQUIPMENT
®
6) Attach antenna connector to
radio board with the cable in the
orientation. Note, in some RC
monitors, cable tie may need to
be cut to attach antenna.
Antenna
Connector
4 )
R e m o v e
t h e
s m a l l
communication board on the far
left. Pull board straight out.
5) Plug radio board into
communication board. Be
careful to line up pins.
Radio Board
Communication
Board
Board
Removed
