Tanco 1540 EH Quick Reference Manual Download

Page: 1 / 4

TRACTOR CONNECTION

1. Hydraulics

Red pipe

> Supply (30-35lpm)

Blue pipe

> Return (

Free flow return!!)

2. Electrics

A. Connect 12V supply to 3pin plug

B. Connect wrapper harness to controller

ENTERING THE WORKING POSITION

1. Remove the wrap arm transport lock.

2. Position the safety arms into the working

position by removing the retaining pin.

3. Adjust the roller arm stops. This is done by

adjusting the position of the pin. This should

be done for different size bales.

4. Install the roll of film and attach the film to

the Cut & Start.

1540 EH QUICK REFERENCE GUIDE

The quick reference guide is not a substitute for the Operators Manual!

Please refer to Operators Manual for more detailed information

Summary of Contents for 1540 EH

Page 1: ...Position the safety arms into the working position by removing the retaining pin 3 Adjust the roller arm stops This is done by adjusting the position of the pin This should be done for different size...

Page 2: ...will return to the folded position and then come to a stop after bringing the film into the cutter IV The wrap arms will then reverse to the center 5 Press Rollers out c to unload the bale 6 To manual...

Page 3: ...ssing any other button except STOP Current No of wraps Target No of wraps Wrapping speed RPM Bale total Grand total No of bales Mode Manual Auto Pause wrapping Open cutter Fast wrap arm rotate Resume...

Page 4: ...NG THE TRANSPORT POSITION 1 Fully close the loading rollers 2 Rotate the wrap arm until it is behind the Cut Start 3 Insert the wrap arm transport lock 4 Lock the safety arm into the transport positio...