Welcome to your Pool-‐Mate Pro. Here is quick start guide and
overview of how to make the watch and software work.
The Pro package consists of a special Pool-‐Mate watch and USB pod. There is an infra-‐red link
between watch and pod so there is no danger of water getting onto contacts etc.
Step 1:
Get some data in to the watch
(see section 1 in the manual).
Set up the pool length so that the watch can calculate distance and speed correctly. Enter
your weight so that number of calories burnt can be estimated. Press start button and start
swimming, hold it down for 2 seconds to stop!
Step2:
Download the software
(section 8).
The software consists of three programs:
1.
Driver for the USB pod.
Important: Must be installed before connecting the pod
2.
Pool-‐Mate Link. Downloads your data.
3.
Pool-‐Mate Pro application. Shows the data on your computer.
The software can be downloaded from http://
www.swimovate.com/downloads
.html
The driver and link are supplied in a single archive (PoolMateSetup.exe) and the PC software in
another. You need to select the correct PC software installer for your operating system and
download both files.
Step3:
Install the software
Start with the driver and link.
Run
PoolMateSetup.exe
by double clicking on it. The Driver and Link software will be extracted to
C:\PoolMateSetup
1, Start with the driver.
Go into the
C:\PoolMateSetup\USBdriver
folder and double click
setup.exe
.
Follow the instructions and click on accept the license. The driver will be installed for you.
Connect the pod to a spare USB port using cable provided and place on a flat table. The computer
should detect the new device and complete installation of the driver. This may take a minute or two.
2,
Install the link software
Go into the
C:\PoolMateSetup\PoolMateLink
folder and double click
setup.exe
. This will talk you
through the Link setup.
Summary of Contents for Pool-Mate Pro
Page 3: ... ...
