LED Exit and Emergency Light
Important: Read all instructions prior to installation.
XSC-x
XSC-x
Total Power Consumption
3 Watts
Operating Voltage Range
120/277 VAC
Operating Temperature
23°–113° F (-5°–45° C)
Operating Humidity
< 90%
Fixture Weight
1 lb 14 oz (0.85 kg)
Maximum Mounting Height
16 ft 9 in (5.11 m)
4400 Earth City Expy, St. Louis, MO 63045
866-590-3533 superbrightleds.com
Included Parts
Specifications
Safety and Notes
1 - fixture
1 - hardware kit
Wiring Diagram
•
This product should be installed and serviced by a certified electrician
in accordance with applicable national, state, and local building and
electrical codes.
• Light must be maintained, tested, and serviced in accordance with all
applicable National Fire Protection Association (NFPA) and local codes.
• To reduce the risk of electric shock, ensure that the main power source
and circuit breakers are switched off before performing any installation
or wiring procedures.
• Avoid looking directly into lamp when illuminated.
• Ensure all mounts are securely attached and will support the weight of
the fixture. Failure to properly support fixture may result in damage or
injury, for which the manufacturer does not assume responsibility.
• Intended for indoor use only.
• Do not mount near radiant heat sources/heaters.
• Use caution when handling or servicing the battery pack.
• Do not break UL sticker seal.
XSC-G
Blue
Blue
Black
Black
Yellow
Yellow
Neutral
Neutral
120 V Power
120 V Wiring
277 V Wiring
Cap
Cap
277 V Power
Converting for Dual-Sided Operation
Converting for Dual-Sided Operation
1.
Carefully remove the “EXIT” panel using a flat-head
screwdriver to release tabs.
2.
Carefully remove the blank real panel using a flat-head
screwdriver to release four tabs around outside and two
inner tabs.
3. Install additional “EXIT” panel in place of blank panel.
¹
¹Limited 2-year warranty on battery.
User Manual
Rev Date: V2 04/09/2020
