Enter
V
<
HARD DISK DRIVE COMPARTMENT
To remove hard disk drive compartment, turn the hard disk
lock to the down position. Lift the hard disk drive compartment
handle and pull the hard disk drive compartment out.
To insert the hard disk drive compartment, turn the hard disk
lock to the down position. Lift the hard disk drive compartment
handle and insert the hard disk drive compartment. To power
on the hard disk drive, turn the hard disk lock to the left
position.
Green light indicates the hard disk drive is storing or
retrieving data. Red light signals the hard disk is reaching
capacity.
PLAYBACK
Press the
PLAY button to playback last recorded video.
The monitor will display a flashing
PLAY message and
the
.
PLAY button will light up indicating the unit is in
playback status
Press the
.STOP button to stop playback at any time.
Press the
PAUSE button during playback to freeze the
display. During the freeze, press this to display one framelfield
of a picture at a time in the forward direction.
MANUAL RECORDING
In live display, press the
OREC button to begin recording
video onto a hard disk with the corresponding settings.
The monitor will display a flashing
REC message and the
button will light up indicating the unit is in recording
status.
.Press the
button to stop recording at any time.
JOG
/
SHUTTLE DIAL FASTISLOW PLAYBACK
Turn the
SHUTTLE dial
to view recorded video at a
faster rate in the forwardlbackward direction. Release the
SHUTTLE dial to return to normal speed.
Each subsequent turn of the shuttle dial to the
increases the rate at 2X, 4X, 8X,16X, 30Xand IOOX
During the freeze
l
press
PAUSE
button):
Turn the
JOG
to display one framelfield of a
picture at a time in the
direction.
Turn the
SHUTTLE dial
to view recorded video at a
slower rate in the forwardlbackward direction. Release the
SHUTTLE dial and then press the
.
PLAY button to return to
the normal speed of playback.
Each subsequent turn of the shuffle to the
decreases the rate at 1/2X, 1/4X, 1/8X and 1/16X
DISPLAY MODE SWITCH
SD
Card
ALARM
rear view
When connected to a multiplexer, press the
MONITOR button
to switch between the multiplexer decoded video and the encoded
video to be displayed. When the button light is on it indicates the
unit is displaying the decoded video. In this mode, the unit doesn't
display the OSD message of the unit on the screen. However, it
doesn't affect the unit's OSD message, which is recorded into hard
disk drive. When the button light is off it indicates the unit is
displaying encoded video (The image switch swiftly).
KEYLOCK OPERATION
For
Key
Lock operation, simultaneously press the
buttons once (at least 3 seconds) to lock the unit; to release
Key
Lock, simultaneously press these two buttons again.
SEARCH RECORDED VIDEO
Press the
SEARCH button to enter the search mode.
Use the
V
button to select
FULL LIST, ALARM
LIST, TIME SEARCH, THUMBNAIL or SD CARD and press
the
ENTER button.
Use the
"A",
to select the specific recorded video and
press the
ENTER button
MENU SETUP
Press the
SETUP button to enter the setup menu.
Use the
"A",
buttons to navigate through
menus. Press again to exit the setup mode.
Press the
ENTER button to enter the selected menu and
save the settings.
SYSTEM INFORMATION
Press the
DISPLAY button to display the system operation
status on the screen.
INTO S
D CARD
Insert a SD card into the SD slot. Start playback of recorded
video.
Press the
button during playback to freeze the
desired image.
Press the
ENTER button to save the image.
