(Over please)
24148-03A
IMPORTANT
SunStar ZX30/32 Stereo Installation Instructions
(Disregard the INSTALLATION MANUAL supplied with the stereo.)
Follow these instructions carefully.
Check the serial number
label on your sunbed. The model name designates a design series,
by a letter, followed by the bed model (i.e. K-ZX32-3FH). If the first
letter is an H or J you will need to use the hole drilling template
included with this instruction sheet. If it is K or above your sunbed
already includes the needed holes and you can disregard the hole
drilling template and all instructions referring to it. The bench and
canopy have been deleted for illustration purposes only. You do
not need to disassemble your sunbed to perform this installation.
SPACER
SPEAKER
NUT
HOLE DRILLING TEMPLATE 2
Find the template labelled “Power Supply
Bracket”. Carefully cut it out on the dashed
line and apply it to the back of the cross bar
with tape. Drill the four holes with a 5/32”
drill bit where shown. Remove the template.
Pull the sunbed away from the back wall,
enough to work behind it. Remove the Gas
Spring Cover Panel and set aside. If your
Gas Spring Cover Panel does not contain
stereo and speaker holes you will need to
replace it with a new panel.
Install the Stereo Support
Bracket as shown with
(3) unpainted #10 x 1/2”
screws.
Place the Gas Spring Cover Panel face down.
Put four plastic spacers on the screw studs
around the speaker holes. Place the speaker
onto the studs and secure with four nuts, as
shown below.
Find the three brackets shown
in the kit (two Stand Spacer
Brackets and one Power Supply
Bracket). Install them with
unpainted #10 x 1/2” screws.
4
2
3
1
5
6
7
HOLE DRILLING TEMPLATE 3
Find the template labelled “Stereo Support
Bracket”. Carefully cut it out on the dashed
line and apply it to the inside of the right
stand leg with tape. Drill the three holes
with a 5/32” drill bit where shown. Remove
the template.
HOLE DRILLING TEMPLATE 1
Find the template labelled “Stand Spacer
Bracket”. Carefully cut it out on the dashed
line and apply it to the back of the stand
leg with tape. Drill the four holes with a
5/32” drill bit where shown. Use the same
template for the other stand leg. Remove
the template.
