![background image](http://html1.mh-extra.com/html/sunset-healthcare/sunny-neb300bear/sunny-neb300bear_instruction-manual_1400039001.webp)
Troubleshooting
If the device does not turn on:
1. Make sure the plug is firmly inserted into the electrical outlet.
2. Make sure the device has been operating within the limits indicated
in this instructional manual (30 minutes ON/30 minutes OFF).
If the device does not nebulize, or the nebulization
is weak:
1. Make sure the ends of the air tube are fitted tightly onto the main
unit and onto the nebulizer (see connected kit and unit diagram
below)
2. Check whether the nebulizer mask or mouthpiece kit cup chamber is
empty or overfilled with medication.
3. Check whether the nebulizer nozzle is obstructed (see
medicine cup diagram below)
4. Check whether the baffle is inserted properly. The baffle fits over the
medicine cup’s interior cone (see medicine cup diagram below).
Fit tube
ends tightly
Fit tube
ends tightly
Instruction Manual
SUNNY
Pediatric
Compressor
Nebulizer
NEB300BEAR
NEB300BEAR-R
NEB300BEAR-IFU V 1.00
2019-06-04
Deluxe Nasal Pillow CPAP Mask
Item#
CM036
Intended Use
The nasal pillow mask is intended to provide an interface for Continuous Positive Airway Pressure (CPAP) or bilevel system.
The mask to be used by adult patients (>66lb/30kg) for whom positive airway pressure has been prescribed. The mask is for
single-patient re-use in the home environment and multi-patient re-use in the hospital/institutional environment.
Caution
US federal law restricts this device to sale by or on the order of a physician.
Excluding patient population
This mask may not be suitable for patients with the following conditions: impaired cardiac sphincter function, excessive
reflux, impaired cough reflex and hiatal hernia. It should not be used if the patient is unresponsive, obtunded, unable to
remove the mask, or uncooperative.
Warnings
This mask is designed for use with CPAP or bilevel systems recommended by your health care professional or respiratory
therapist. Do not wear this mask unless the CPAP or bilevel system is turned on and operating properly. Do not block or try
to seal the exhalation port.
CPAP systems are intended to be used with special masks with connectors which have vent holes to allow continuous flow of air out of the mask. When the
device is turned on and functioning properly, new air from the device flushes the exhaled air out through the attached mask exhalation port. However, when
the device is not operating, enough fresh air will not be provided through the mask, and exhaled air may be re-breathed. At low pressures, the airflow through
the exhalation port may not be enough to clear all of the exhaled gas (CO2) from the mask. You may breathe in some of the air that you have exhaled.
If oxygen is used with the device, the oxygen flow must be turned off when the device is not operating.
• When the device is not in operation, and the oxygen flow is left on, oxygen delivered into the ventilator tubing may accumulate within the device enclosure.
Oxygen accumulated in the device enclosure will create a risk of fire.
• Oxygen supports combustion. Oxygen should not be used while smoking or in the presence of an open flame.
• At a fixed flow rate of supplemental oxygen flow, the inhaled oxygen concentration will vary, depending on the pressure settings, patient breathing pattern,
nasal interface selection, and the leak rate.
Some users may experience skin redness. If this happens, contact your health care professional.
Cleaning the Mask
The cushion, nasal interface, and tubing should be cleaned daily or as needed.
• Hand wash in warm water with a mild liquid dishwashing detergent. Do not use bleach, alcohol, or cleaning solutions
containing alcohol. Do not use cleaners containing conditioners or moisturizers.
• Rinse thoroughly. Pat with a towel and air dry completely before use
• Inspect all parts for damage or wear; replace if necessary.
Cleaning the Headgear
Hand wash the headgear weekly or as needed. Lay the headgear flat or line dry.
Disposal
The nasal pillow mask does not contain any hazardous substances and may be disposed of with your normal
household refuse.
latex
free
Manufactured for
Sunset Healthcare Solutions
180 N Michigan Ave Ste 2000
Chicago, IL 60601
SunsetHCS.com
DO NOT PRINT THIS LAYER.
100%
1 Color
1
PH 2.23.17
A4 (210mm x 297mm)
res036-ifu.pdf
When printing with default
Acrobat autoscale settings.
Cleaning
Cleaning of the compressor
Use a clean dry cloth and mild detergents to clean the outside of
the unit.
ATTENTION
During cleaning, make sure the internal parts of the unit
are not in contact with liquids and the power cord is disconnected.
Cleaning and disinfection of the accessories
After each use, disassemble T-piece kit into 3 sections. Wash in warm
soapy water and rinse well. Wipe with a paper towel and allow to air dry.
Do not boil or autoclave angled mouthpieces, air tubes, or masks.
It is important that the cleaning instructions are carefully
followed to ensure optimal operation.
Replacement of Nebulizer Kit
RES2210 Pediatric Aerosol Mask
(Included in NEB300BEAR and NEB300BEAR -R)
The pediatric aerosol mask should be replaced after a long period of
inactivity, or if it is obstructed by dry medication, dust, etc. With normal
use, the pediatric aerosol mask should last 1 month.
RES091 Disposable Nebulizer Kit
with Clear Tubing
(Included in NEB300BEAR and NEB300BEAR -R)
The disposable nebulizer T-Piece kit should be replaced after a long
period of inactivity, or if it is obstructed by dry medication, dust,etc. With
normal use, the disposable nebulizer T-piece kit should last 1 month.
RES093 Reusable Nebulizer Kit
with Green Tubing
(Included in NEB300BEAR-R)
The reusable nebulizer T-Piece kit should be replaced after a long period
of inactivity, or if it is obstructed by dry medication, dust, etc. With
normal use, the reusable nebulizer T-piece kit should last 6 months.
Replacement of the filter
The filter is to be replaced after approximately 30 hours of use, or when
it appears dirty. Open the filter holder to replace the filter with a new
one. Use Sunset BF018 Nebulizer Filters.
Do not use the device without the filter.
Maintenance and Repair
Never open the device. There are no serviceable parts within the unit.
The compressor does not require lubrication or maintenance.
Exploded view
Medicine cup
Visual Guide
T-piece kit
Mask
Baffle
Nozzle
Closed view