![background image](http://html.mh-extra.com/html/storeyourboard/naked-rack-series/naked-rack-series_instructions_1382676001.webp)
Rack Contents:
•
(1) Wall Rack
(Mounting Rod & Attachment Arm)
•
(2) Lag Screws & (2) Washers
•
(1) Hook & Loop Strap
•
(1) Set Screw per rack
w/ (
1) hex key per kit
Weight Limits:
•
Up to
50 lbs per rack
(evenly distributed)
Installation Instructions
Prior to installing, please visit the product details page at
www.storeyourboard.com to view installation videos.
Recommended
Tools:
Drill/Driver
Nut drivers
Drill bits
Stud Finder & Pencil
Tape Measure
Part Identification:
(A) Mounting Rod
(B) Attachment Arms
(C) Set Screw
(D) Lag Screw
(E) Washers
(F) Hook & Loop Strap
(A)
Updated: 8-27-2019
1. Locate Studs:
Determine the wall space where the Naked Rack for Bike Rack is to be located. Use a Stud Finder
to locate your nearest wall stud to the desired rack location, mark the stud location with a pencil.
Do Not anchor through drywall only.
2. Mark Mounting Points:
Hold the rack Mounting Rod (A) up to the wall at the desired mounting height
(consider the length of the bike to stored as well as the desired height off the floor). Align rack mounting holes
with the marked stud location and mark the mounting hole locations with a pencil.
Note: The holes shall be vertical and centered on the marked stud. The rack mounting slots provide desired
angle adjustment after installing.
3. Pre-drill Mounting Holes:
Locate a drill bit that is slightly narrower than the threads of the lag screw (D)
provided. With the selected drill bit, drill holes into the wall studs at the mounting points marked in step 2.
The depth of the hole should be similar to that of the lag screw provided.
4. Secure Mounting Rod to Wall:
Locate a nut driver (or socket) sized for the lag screws provided. Place a washer
(E) over the lag screw (F) and install thru the top slot in the Mounting Rod (A). The Mounting Rod has a hole at
the end of the rod which shall face the ground once secured to the wall. Tighten the lag screw to secure
Mounting Rod to the wall. Repeat for the second lag screw and bottom slot in the Mounting Rod.
THE
Naked Rack
for
BIKE
PART OF THE
Naked Rack
LINE OF PRODUCTS
(E)
(D)
(B)
(F)
(C)
- Instructions continued on reverse -