Quick-start guide
Manual Revision: 10/24/2016
For the latest information, technical specifications, and support for
this product, please visit www.StarTech.com/SU2DUPERA11.
Package contents
• 1 x SATA/USB duplicator and eraser
• 1 x universal power adapter (NA/JP, UK, EU, AU)
• 2 x drive-connector cables
• 2 x drive pads
• 1 x quick-start guide
System requirements are subject to change. For the latest
requirements, please visit
www.StarTech.com/SU2DUPERA11
.
SU2DUPERA11
Standalone Drive Duplicator and Eraser for USB Flash Drives and 2.5”/3.5” SATA SSDs /HDDs
*actual product may vary from photos
Important:
Read and understand the entire manual before
you use this product, and follow the instructions as they are
outlined in the manual.
Failure to do so might result in property damage or device
failure.
Product diagram
USB source
port
SATA source port
LCD display
Menu navigation
buttons
OK button
Exit button
USB source LEDs
SATA source LEDs
USB target port
SATA target
port
USB target LEDs
SATA
target LEDs
Power switch
Power jack
Erase and copy modes
The SU2DUPERA11 supports five erase modes and four copy modes.
Mode
Definition
Erase modes
Quick erase
The partition table is quickly erased.
Full erase
The entire drive is erased.
DoD 5220.22-M erase
A three-pass overwrite based on
DoD 5220.22-M specifications
is completed.
DoD 5220.22-M erase
and compare
A three-pass overwrite based on
DoD 5220.22-M specifications
is completed and compared.
Secure erase
The ATA Secure Erase feature of the
drive is executed.
Note:
The Secure Erase feature isn’t
supported on USB drives.
Copy modes
Copy system and files
Only the data area of the source drive is
copied and the empty space
isn’t copied.
Copy all partitions
All of the partitions and data, including
blank partitions, are copied. Blank space
and nonpartition space isn’t copied.
Copy the whole drive
The entire drive is copied, including
empty space.
Copy a percentage
A specified percentage range of the
drive is copied.
About copying drives
You can use the SU2DUPERA11 to copy SATA drives in any of the
following configurations:
• SATA drive to SATA drive
• SATA drive to USB drive
• USB drive to USB drive
• USB drive to SATA drive
Copy a SATA or USB drive
Note:
You should avoid plugging SATA drives directly into the
SU2DUPERA11, as it puts undue strain on the device connectors. Use
the drive-connector cables instead.
Warning!
Make sure that the storage capacity of the target drive
is larger than or equal to the storage capacity of the source drive.
Otherwise, you will get an error when you try to copy your drive.
Warning!
After you begin copying a drive, don’t disconnect either
drive or interrupt the process before it has finished. Doing so might
result in damage to the drive or lost data.
