Unplug
Pump
Low Water
IL2059
RESETRESET
TESTTEST
IL2059
Pumps down
to 1/8-in
RESET
RESET
TESTTEST
GFCI Outlet
IL2059
1-3/4-in
minimum
Garden
Hose
Adapter
Garden
Hose
1. Attach hose adapter
to pump.
Connect hose
adapter to garden
hose and route hose
to discharge point.
2. Set pump on hard
surface in water
before starting. Water
must be a minimum
of 1-3/4-in deep for
pump to operate.
Avoid placing pump
directly on sand, dirt,
or mud.
3. Plug pump into a
properly grounded
115 V AC power
outlet.
4. The pump will run for
15 seconds after it is
plugged in. If water is
being pumped during
this 15 seconds, the
pump will continue
operating until water
level drops to 1/8-in. At
that time, the pump will
shut off.
After the pump shuts
off, it will automatically
turn back on every
three minutes for 15
seconds and then
turn back off if it is not
pumping water. To re-
start the pump sooner,
unplug the pump for a
few seconds and plug it
back in.
5. To prevent
unnecessary wear,
unplug the pump
from the power
output when not in
use.
QUICK REFERENCE GUIDE.
SEE INSTRUCTION MANUAL FOR
COMPLETE DETAILS.
SUBMERSIBLE SENSOR
UTILITY PUMP
MODEL 3SUEL, 2SUEL, 453663
SW1428 B
WARNING:
FOR YOUR PROTECTION, ALWAYS
DISCONNECT PUMP FROM POWER
SOURCE BEFORE HANDLING.
NOT DESIGNED FOR CONTINUOUS,
ONGOING OPERATION. DESIGN LIFE IS
4,500 ACCUMULATED HOURS.
NOTE: This pump does not
contain a water level sensor
but will automatically shut
itself off when water level
drops to 1/8-in. A built-in
timer turns the pump back
on after 3 minutes and it will
continue pumping as long
as water is present.
