8M00356
REV. 14
February 10, .2020
1
www.standardchange.com
1-800-968-6955
Technical Phone Support is from 8:00AM to 7:30PM E.S.T., Monday-Friday
Walk-in Service is from 8:00AM to 4:30PM E.S.T., Monday-Friday
Parts Department is from 8:00AM to 6:00PM E.S.T., :Monday-Friday
MC CHANGER CABINET INSTALLATION
INSTRUCTIONS
Standard Change-Makers manufactures change machines in the following cabinet styles:
1) Free standing consoles, 2) Front loading wall mount, 3) Through-the-wall rear load
and 4) Slim-line vending changer. Because physical locations vary, we do not suggest an
exact method of installation. To assure proper operation of your Standard bill changer the
following general guidelines should be observed:
1.
Full swing of the door when open.
2.
Wall construction: For maximum security, it is recommended that the changer be
installed on a wall made of cement block, brick or other type of masonry.
WARNING!!!
Welding the cabinet to any kind of mounting could cause damage to electrical components
within the machine! Warping of the cabinet may also occur. Welding of any kind to the
cabinet during installation will void the manufacturer’s warranty!
If welding is ultimately necessary, all components within the machine must be removed
prior to welding! Please contact our Service Department with any questions.
3.
Rear loading changers (through the wall mountings) should always open into a secure
location that has a locked door and no windows.
4.
Good overhead lighting is highly recommended in the area that your changer is
located not only for your customers but for additional security.
5.
Accessibility of power supply.
(120 Volt/ 60 Hertz on its own grounded circuit – 10
amp minimum required.)
6. Carwash locations will want to locate their changers out of reach of high-pressure
hoses.
7. The changer should be located so that any water runoff from the roof of the building
does not run down the face of the changer. A protective awning or shelter is highly
recommended for all outdoor installation sites.
