Inductive Bluetooth Ballpoint Pen
The bluetooth ball-pen is designed to pair with cellphone
and transmit voice signals to electrical earpieces wirelessly.
It can works with all kinds of electrical earpieces.
Each set of SEA09 ball-pen including below parts:
1 x bluetooth ball-pen
1 x AC power adaptor (UK default)
Bluetooth Ball-Pen
Power Adaptor
Microphone Hole
Bluetooth Indicator
Bluetooth Switch
Ball-Pen Controler
Recharge Hole
Quick Start
Step 1> Overview of bluetooth ball-pen
Please refer to up right sketch to see positions
of microphone hole, indicator, bluetooth switch,
ball-pen and recharge hole.
Press bluetooth switch to operate the device.
Bluetooth indicator is concealed underneath pen clip. In order to
see indicator clearly, please cover upper indicator
position by hand or operate in dark place.
Turn controller to left to screw out ball-pen and add new ink
refill if required
Ink Colour is black.
Step 2> Recharge battery for about 2 hours
Press pen clip to
control bluetooth switch
Cover indicator position with hand
to see bluetooth indicator clearly
A. Screw out pen upper part and find recharge hole.
B. Connect adaptor with electrical outlet and recharge.
C. Indicator turns red when successfully connected.
If indicator does not turn on, please unplug and try again.
D. Full charge needs 2~3 hours. When fully charged indicator
turns from red to blue.
Note: Make sure bluetooth ball-pen is powered off while recharging.
Bluetooth ball-pen will not function while recharging.
Step 3> Pair with cellphone
To electrical outlet
wall charger etc
To ball-pen
recharge hole
A. Put bluetooth ball-pen to pairing mode by pressing and holding the pen clip.
The indicator will flash blue initially then from blue to red. Once indicator flashes blue to red it is in pairing mode
B. Enable bluetooth function in cellphone and search for new device. “TE53" should appear, select it and press OK.
Enter password 0000 if prompted and press OK.
After successfully paired, indicator will slowly flash blue
Step 4> Test and use
Load battery into earpiece and place inside ear canal. Pair bluetooth ball-pen with cellphone then hold near to earpiece.
On your cell phone dial the number you want to call. You will hear voice in earpiece after connected
Step 5> Turn off/on bluetooth ball-pen
To save battery power, please turn off bluetooth neckloop if do not use for long time
Turn off – Press and hold pen clip until blue indicator flash twice
Turn on – Press and hold pen clip, indicator will turn on. When bluetooth ball-pen is connected to paired cellphone and
ready for use, blue indicator will flash shortly.
